GLOBUG LIGHTING SYSTEM — MAINTENANCE
Filter Replacement
WARNING - HOT SURFACE (LAMP FRAME)
DO NOT replace filter immediately, allow a sufficient amount of time for the lamp assembly to cool down before changing filter.
1.Remove the balloon as described in the "Removing the Lamp/Balloon" section.
2.Disconnect the lamp power cable as shown in Figure 23.
3.Rotate the balloon/lamp base assembly so that the filter is facing upwards. See Figure 41.
Figure 41. Balloon/Lamp Placement
5.Install a new filter over the brace as shown in Figure 43. Be sure to align the cut of the filter over the brace.
Figure 43. Filter Placement
CAUTION - FILTER ALIGNMENT
When placing the filter element, always align the cut of the filter on top of the brace. This will keep the filter from being dislodged and getting damaged.
4.Turn the three locking tabs (Figure 42) inward to release the plate. Remove plate and filter.
6.Turn the three retaining tabs (Figure 44) outward so that they touch the lamp base.
Figure 44. Filter/Plate Install Figure 42. Filter Removal
PAGE 34 — GLOBUG LIGHTING SYSTEM — OPERATION & PARTS MANUAL — REV. #3 (03/22/06)