GLOBUG LIGHTING SYSTEM — MAINTENANCE
Installing a New Lamp
1.When installing a new lamp (Figure 27) use only MQ recommended type lamp. See parts section of this manual. Failure to use correct type lamp could adversely affect lighting capability and may cause damage to the equipment.
2.Push down and hold the lamp holder (spring loaded) away from the lamp. Screw the lamp (turn clockwise) into the lamp socket. Gently place the lamp holder firmly over the top of the lamp. This will prevent the lamp from touching the lamp guard or pipe frame.
2.Zip up the zipper at the bottom (Figure 24) of the balloon and pull down the balloon envelope to cover the lamp
3.Place the lamp/balloon assembly back onto the mast adapter stand (Figure 23).
4.With a 5 mm allen wrench, tighten the set screw to 28 ~ 38 ft. lbs (38 ~ 51
5.Reinstall the protective cover over the balloon/lamp as- sembly. Be sure to fold the velcro tabs.
6.Reconnect the power cables.
Replacing the Balloon
1.Follow the procedures as outlined in the "Removing the Balloon Lamp" assembly section.
2.Unzip the zipper at the bottom and top of the balloon. Slide the balloon over the top of the lamp guard as shown in Figure 29.
Figure 27. Installing the Lamp
Re-Installing the Lamp/Balloon Assembly
1.Reinstall the lamp guard (Figure 28). Be careful not to install the lamp guard in the wrong direction.
Figure 29. Removing the Ballon
3.Slide the new balloon over the top of the lamp guard as shown in Figure 30. Zip up the zipper at the bottom and top of the balloon.
Figure 30. Removing the Ballon Figure 28. Installing the Lamp Guard
GLOBUG LIGHTING SYSTEM — OPERATION & PARTS MANUAL — REV. #3 (03/22/06) — PAGE 29