Multiquip GB114BC manual Globug Lighting System Maintenance

GLOBUG LIGHTING SYSTEM — MAINTENANCE

For a prolonged life cycle an extended quality follow the recommended GloBug service guidelines as referenced in Table 3.

TABLE 3. PERIODIC CHECK AND MAINTENANCE

FIGURE		PART			CHECK ITEM	SOLUTION
	L1	Frame Pipe		Frame pipe skewed?		Replace.	❖
	L2	Lamp Holder		Lamp holder loose?		Tighten or replace.	❖
Lamp
	L3	Lamp (Base)		Lamp base loose?		Screw in securely.	❖
	L4	Lamp		Defective lamp?		Replace.	❖
	L5	Cable/Connector		Cable disconnected or loose?		Connect securely.	■
	B1	Balloon (Envelope)		Defective or dirty?		Replace.	❖
Balloon	B2	Zipper		Broken?		Replace.	❖
	B3	Fan Motor (Blower)		Working properly?		Repair or replace.	❖
	M1	Mast Sliding Surface		Slides smoothly?		Apply grease.	●
	M2	Wire Rope		Damaged?		Apply grease or replace.	❖
Mast	M3	Wire Rope End		Is wire end damaged (caulking)?		Replace.	❖
	M4	Winch		Defective winch brake ?		Repair or replace.	❖
	M5	Safety Stop		Safety latch defective?		Repair or replace.	▲
	C1	Counter-Weight		Travels smoothly?		Spray grease.	●
	C2	Outriggers		Travels smoothly?		Spray grease.	●
	C3	T-handle and Wheels		Proper movement.		Tighten securely.	■
	C4	Bolt for Handle		Check if bolt is not loose.		Tighten securely.	■
	C5	Brake Pedal		Linkage working correctly.		Check, spray grease	❖
Cart	C5	Brake Pedal		Notch worn-out?		Replace.	❖
	C6	Hanger		Check if the installation is not loose.		Fasten securely.	■
	C7	Front Wheel Pivot		Turns smoothly?		Check, apply grease.	●
	C8	Tires		Tire pressure 35.5 psi (294 kPa)?		Adjust.	❖
	C9	Link for Front Shaft		Linkage moves smoothly?		Spray grease.	●
	C10	Brake		Working properly?		Adjust.	❖
Electric	E1	Power Cable		Defective or worn cable?		Replace.	❖
	E2	Non-load Voltage		Is generator output 125 VAC?		Adjust or replace generator.	●
	❖ - Daily Check		■ - Every 20 Hours		● - Every 100 hours	▲ - Every 500 hours

GLOBUG LIGHTING SYSTEM — OPERATION & PARTS MANUAL — REV. #3 (03/22/06) — PAGE 37