Multiquip DCA800SSK2 Generator OUTPUTS/GAUGE Reading, AC Voltmeter Gauge Reading, 240/3Ø Position

GENERATOR OUTPUTS/GAUGE READING

HOW TO READ THE AC AMMETER AND AC VOLTAGE GAUGES

The AC ammeter and AC voltmeter gauges are controlled by the AC ammeter and AC voltmeter changeover switches.

Both of these switches are located on the control panel and DO NOT effect the generator output. They are provided to help observe how much power is being supplied, produced at the UVWO terminals lugs.

Before taking a reading from either gauge, confi gure the Voltage ChangeOver Board (Figure 12) which produces the desired output voltage.

Figure 12. Voltage ChangeOver Board

240/3Ø Position

AC Voltmeter Gauge Reading

Place the AC Voltmeter ChangeOver Switch (Figure 13) in the WU position and observe the phase to phase voltage reading between the W and U terminals as indicated on the AC Voltmeter Gauge (Figure 14).

AC Ammeter Gauge Reading

Place the AC Ammeter ChangeOver Switch (Figure 16) in the U position and observe the current reading (load drain) on the U terminal as indicated on the AC Ammeter Gauge (Figure 16). This process can be repeated for terminals V and W.

Figure 15. AC Ammeter	Figure 16. AC Ammeter
ChangeOver Switch	(Amp reading on U Lug

NOTICE

The ammeter gauge will only show a reading when the Output Terminal Lugs are connected to a load and in use.

Figure 13. ACVoltmeter	Figure 14.ACVoltmeter Gauge
ChangeOver Switch	(Volt reading onWU Lug

PAGE 26 — DCA800SSK2 60 HZ GENERATOR • OPERATION AND PARTS MANUAL — REV. #0 (09/03/09)