Multiquip DCA800SSK2 manual Generator Shutdown Procedures, Normal Shutdown Procedure

GENERATOR SHUTDOWN PROCEDURES

NORMAL SHUTDOWN PROCEDURE

To shutdown the generator, use the following procedure:

1.Place the three auxiliary circuit breakers in the OFF position (Figure 36)

2.Place the engine speed switch (Figure 58) in the “LOW” (down) position.

Figure 58. Engine Speed Switch (Low)

3.Let the engine cool by running it at low speed for 3-5 minutes with no load applied.

4.Place the MPEC Control Switch (Figure 59) to the OFF/RESET position.

Figure 59. MPEC Control Switch (Off/Reset)

5.Verify that all the status LEDs on the MPEC display are OFF (not lit).

6.Set the battery ON/OFF switch (Figure 60) to the "OFF" position.

EMERGENCY SHUTDOWN PROCEDURE

1.To stop the engine in the event of an emergency, PUSH the emergency stop button (Figure 61) inward. This button is located on the engine operating panel, see Figure 5.

Figure 61. Emergency Stop Button

Figure 60. Battery Switch (OFF)

7.Remove all loads from the generator.

8.Inspect entire generator for any damage or loosening of components that may have occurred during operation.

DCA800SSK2 60 HZ GENERATOR • OPERATION AND PARTS MANUAL — REV. #0 (09/03/09) — PAGE 37