Multiquip DCA800SSK2 Verify that the main circuit breaker on lamp is lit on, Ammeter No Load

GENERATOR STARTUP PROCEDURE (MANUAL)

14. Press the main circuit breaker "ON" switch (Figure 52).

Figure 48. Ammeter (No Load)

11.The engine oil pressure gauge (Figure 49) will indicate the oil pressure of the engine. Under normal operating conditions the oil pressure is approximately 28 to 85 psi. (193~586 kPa).

Figure 49. Oil Pressure Gauge

12.The coolant temperature gauge (Figure 50) will indicate the coolant temperature. Under normal operating conditions the coolant temperature should be between 167°~203°F (75°~95°C) (Green Zone).

Figure 52. Main Circuit Breaker ON Switch

15.Verify that the main circuit breaker "ON" lamp (Figure 53) is lit (ON).

Figure 53. Main Circuit Breaker ON Lamp

16.Place the three auxiliary circuit breakers in the ON position (Figure 54).

Figure 50. Coolant Temperature Gauge

13.The tachometer gauge (Figure 51) will indicate the speed of the engine when the generator is operating. Under normal operating conditions this speed is approximately 1800 RPM’s.

Figure 51. Engine Tachometer Gauge

Figure 54. Main, Aux. and GFCI

Circuit Breakers (ON)

17.Verify that the generator’s ammeter (Figure 55) reads the anticipated amount of current with respect to the load. The ammeter will only display a current reading if a load is in use.

Figure 55. Ammeter (Load)

18.The generator will run until manually stopped or an abnormal condition occurs.

DCA800SSK2 60 HZ GENERATOR • OPERATION AND PARTS MANUAL — REV. #0 (09/03/09) — PAGE 35