
engine Control Panel
1 |
2 |
3 |
4 |
OFF
STOP RUN
START
INCREASE DECREASE
5
Figure 4. Engine Control Panel
The definitions below describe the controls and functions of the Engine Control Panel (Figure 4).
1.Engine Warning Lamps — There are four engine warning lamps, they are defined as follows:
a.Low Oil Pressure Alarm Lamp — During normal operation of the generator this lamp
will remain OFF. When the ignition
switch is placed in the RUN position to start the engine, the lamp will be
ON. When the oil pressure rises after
If this lamp is ever lit (ON) during normal operation of the generator, the emergency shutdown system will stop the engine automatically.
b.Water Temperature Alarm Lamp — This lamp goes ON when the cooling water temperature rises abnormally. If
the lamp goes ON during normal operation of the generator, the emergency shutdown system will stop the engine automatically.
c.Battery Charge Alarm Lamp — This lamp is
ON when the output voltage of the alternator drops below a set value. If this lamp is ON during normal operation, the emergency shutdown system will immediately stop the engine.
d.
In addition this lamp displays engine trouble shooting faults via flashes (blinking). See engine trouble codes in the maintenance section of this manual.
2.Fuel Gauge – Indicates amount of diesel fuel available
3.Hour Meter – Indicates amount of time generator has been in use.
4.Engine Speed Switch – This switch controls the speed of the engine (low/high).
5.Ignition Switch – Three position switch, stop, run and start. Insert ignition key to start and stop engine.
page 18 — DCA40sskU/ku4i 60 hz Generator • operation and parts manual — rev. #1 (03/11/13)