OUTPUT TERMINAL PANEL FAMILIARIZATION
Connecting Loads
Loads can be connected to the generator by the Output Terminal Lugs or the convenience receptacles (Figure 11). Make sure to read the operation manual before attempting to connect a load to the generator.
To protect the output terminals from overload, a
Over Current Relay
An over current relay (Figure 12) is connected to the main circuit breaker. In the event of an overload, both the circuit breaker and the over current relay may trip. If the circuit breaker can not be reset, the reset button on the over current relay must be pressed. The over current relay is located in the control box.
Figure 12. Over Current Relay
Figure 11. Connecting Loads
page 22 — DCA40sskU/ku4i 60 hz Generator • operation and parts manual — rev. #1 (03/11/13)