Multiquip DCA-25SSIU2 Air Removal, Cleaning the Fuel Strainer, Check Oil Level, Generator Storage

Page 38

DCA-25SSIU2 (60 HZ)— MAINTENANCE

Air Removal

If air enters the fuel injection system of a diesel engine, starting becomes impossible. After running out of fuel, or after disassembling the fuel system, bleed the system according to the following procedure.

To restart after running out of fuel, turn the switch to the “ON” position for 15-30 seconds. Try again, if needed. This unit is equipped with an automatic air bleeding system.

Cleaning the Fuel Strainer

Clean the fuel strainer if it contains dust or water. Remove dust or water in the strainer cap and wash it in gasoline. Securely fasten the fuel strainer cap so that fuel will not leak. Check the fuel strainer every 200 hours of operation or once a month.

Check Oil Level

Check the crankcase oil level prior to each use, or when the fuel tank is filled. Insufficient oil may cause severe damage to the engine. Make sure the generator is level. The oil level must be between the two notches on the dipstick as shown in (Figure 31).

Replacing Oil Filter

To remove the oil filter, grip the filter body and turn counter-clockwise

Apply a film of oil to the rubber seal gasket.

Place the oil filter body onto the oil filter spindle by turning clockwise. DO NOT over tighten.

After the oil filter has been replaced, the engine oil will drop slightly. Run the engine for a while and check for leaks before adding more oil if needed. Clean excessive oil from engine.

Replacing Fuel Filter

Replace the fuel filter cartridge with new one every 500 hours or so.

Loosen the drain plug at the lower top of the fuel filter. Drain the fuel in the fuel body together with the mixed water. DO NOT spill the fuel during disassembly.

Vent any air.

.

Flushing Out Radiator and Replacing Coolant

Open both cocks located at the crankcase side and at the lower part of the radiator and drain coolant. Open the radiator cap while draining. Remove the overflow tank and drain.

Check hoses for softening and kinks. Check clamps for signs of leakage.

Flush the radiator by running clean tap water through radiator until signs of rust and dirt are removed. DO NOT clean radiator core with any objects, such as a screwdriver.

Tighten both cocks and replace the overflow tank.

Replace with coolant (Table 13 for correct mixture).

Close radiator cap tightly.

WARNING - BURN HAZARDS

 

Allow engine to cool when flushing out

 

radiator. Flushing the radiator while hot

 

could cause serious burns from water

o r

steam.

 

Generator Storage

For longe term storage of the generator the following is recommended:

Fill the fuel tank completely. Treat with a fuel stabilizer if necessary.

Completely drain the oil from the crankcase and refill if necessary with fresh oil.

Clean the entire generator, internal and external.

Cover the generating set and store in a clean, dry place.

Disconnect the battery.

Make sure engine coolant is at proper level.

If generator is mounted on a trailer, jack trailer up and place on block so tires do touch the ground or remove tires.

PAGE 38 — DCA-25SSIU2 (60 HZ)— OPERATION AND PARTS MANUAL — REV. #0 (01/27/06)

Image 38
Contents Parts List NO. M1870300804 Model DCA-25SSIU2Page Heres HOW to GET Help Wilmington Ave Carson, CATable of Contents Parts Ordering Procedures When ordering parts Please supply the following informationDCA-25SSIU2 60 HZ- Specifications DCA-25SSIU2 60 HZ- Dimensions TOP, Side and Front DimensionsDCA-25SSIU2 60 HZ Safety Message Alert Symbols Has been developed to provideDCA-25SSIU2 60 HZ Safety Message Alert Symbols This generator, other property, orBurns General SafetyDCA-25SSIU2 60 HZ- Rules for Safe Operation Generator Grounding Electrical SafetyDCA-25SSIU2 60 HZ- Rules for Safe Operation Maintenance Safety Battery SafetyTowing &Transporting Safety EmergenciesDCA-25SSIU2 60 HZ- Generator Decals Generator DecalsDCA-25SSIU2 60 HZ- Generator Decals DCA-25SSIU2 60 HZ- Installation Indoor Installation DCA-25SSIU2 60 HZ- InstallationOutdoor Installation When connecting the generatorDCA-25SSIU2 60 HZ- General Information DCA-25SSIU2 60 HZ- Major Components Generator Major ComponentsDCA-25SSIU2 60 HZ- Generator Control Panel DCA-25SSIU2 60 HZ- Engine Operating Panel DCA-25SSIU2 60 HZ- Output Terminal Panel Familiarization Output Terminal FamiliarizationDCA-25SSIU2 60 HZ- Output Terminal Panel Familiarization F.C.I. Receptacle 120VAC Gfci ReceptaclesConnecting Loads Blower FanDCA-25SSIU2 60 HZ- Load Application Single Phase LoadThree Phase Load Motors and motor-drivenGenerator OutputVoltages Voltage Selector SwitchDCA-25SSIU2 60 HZ- Generator Outputs Generator AmperageReading Amperage How to Read the OutputTerminal GaugesDCA-25SSIU2 60 HZ- Gauge Reading Uvwo Terminal Output Voltages Three-Phase PositionDCA-25SSIU2 60 HZ- Output Terminal Panel Connections 3Ø-240/139 Output Terminal Lug Voltages1Ø 240V/120V Output Terminal Lug Voltages DCA-25SSIU2 60 HZ- Output Terminal Panel Connections3Ø 480/277 Output Terminal Lug Voltages Lubrication Oil DCA-25SSIU2 60 HZ- PRE-SETUPCircuit Breakers Fuel CheckRefueling DCA-25SSIU2 60 HZ- PRE-SETUPRefueling Procedure Operation FreezingWeather Cleaning the RadiatorAir Cleaner Fan Belt Tension Vol % Freezing PointWhen connecting battery do the following BatteryBattery Cable Installation WiringEngines exhaust contains harmful emissions DCA-25SSIU2 60 HZ- Generator START-UP ProcedureBefore Starting Direct exhaust away from nearby personnel Frequency Meter Hz Remove all loads from the generator DCA-25SSIU2 60 HZ- GEN. START-UP PROCEDURE/SHUTDOWNTurn the ignition switch key to the Stop position DCA-25SSIU2 60 HZ- Maintenance Check Oil Level Cleaning the Fuel StrainerAir Removal Replacing Oil FilterDCA-25SSIU2 60 HZ- Maintenance To ensure adequate startingDCA-25SSIU2 60 HZ-TRAILER Maintenance Trailer MaintenanceBrakes DCA-25SSIU2 60 HZ-TRAILER MaintenanceBrake Adjustment Check the wheel and drum for free rotationSuspension Tires/Wheels/Lug NutsTire Wear/Inflation Start all wheel lug nuts by hand DCA-25SSIU2 60 HZ-TRAILER MaintenanceLug Nut Torque Requirements DCA-25SSIU2 60 HZ-TRAILERWIRING Diagram DCA-25SSIU2 60 HZ- Generatorwiring Diagram Generator Wiring DiagramDCA-25SSIU2 60 HZ- Enginewiring Diagram DCA-25SSIU2 60 HZ-TROUBLESHOOTING Generator Generator TroubleshootingStarter does not run DCA-25SSIU2 60 HZ-TROUBLESHOOTING EngineEngine does not start DCA-25SSIU2 60 HZ-TROUBLESHOOTING Engine If more than one of the same Explanation of Code in Remarks ColumnItems Found In the Items Number Column Part number on this Suggested Spare Parts list DCA-25SSIU2 60 HZ- Suggested Spare PartsDCA-25SSIU2 60 HZ- Generator Assy 0601822630 B11102006027961025004 8001070003DCA-25SSIU2 60 HZ- Control BOX Assy 0021004075 M12130009020601870430 0601842384Control BOX ASSY.CONT 0601801041 0601808985 AC AMMETER, ACF-6 0~50A/100A5A 06018010400601806859 0601840073DCA-25SSIU2 60 HZ- Engine Operating Panel Assy 0602103092 89704441808944024980 2A# 0601810245 BULB, E-10 T-10 DC18V 0602120095DCA-25SSIU2 60 HZ- Engine & Radiator Assy M1305200304 M19232000440602041210 M1305200204DCA-25SSIU2 60 HZ- Engine & Radiator ASSY. 0603300285 06020225610603306590 0605511395 VALVE, XV500P-8 0603306395 Hose Joint 0602021070DCA-25SSIU2 60 HZ- Outputterminal Assy Output Terminal AssyM9220000104 M1230700003M9220000004 0039308000DCA-25SSIU2 60 HZ- Battery Assy M9103000304 0602220185M9310500014 0602220920DCA-25SSIU2 60 HZ- Muffler Assy 8970420280 0602300390M1333201703 M1333200014DCA-25SSIU2 60 HZ- Fuel Tank Assy DCA-25SSIU2 60 HZ- Fueltank Assy DCA-25SSIU2 60 HZ- Enclosure Assy Enclosure AssyM1423001802 M1413002802M1413400004 M1493104903DCA-25SSIU2 60 HZ- Enclosure ASSY. Enclosure ASSY.CONT33A M1493405604 0016908055M1453003803 M1453003903DCA-25SSIU2 60 HZ- Rubber Seals Assy 0228900725 02289011700228900695 M1490300004DCA-25SSIU2 60 HZ- Nameplate and Decals M1550001603 M1550000104M1550000204 M1550017003Terms and Conditions of Sale Parts FreightpolicyPage Your Local Dealer is
Related manuals
Manual 82 pages 62.92 Kb