Land Pride 4400ex manual Tire Maintenance, Jacking the Vehicle, Shock Absorbers, Electrical System

Page 25

Table of Contents

Section 6: Maintenance

Engine Torques

For engine torque values, see engine owner’s manual.

All Other Torques

For all other torques refer to “Torque Values Chart” page 45.

Tire Maintenance

Use only tires recommended by Land Pride.

It is important for your safety and the safety of others that the tires have correct air pressure. Check air pressure in all four tires before each use. Visually inspect tires for loss of air throughout each day of operation. See Tire Inflation Chart below for correct tire pressure.

Tire Inflation Chart

Tire

Inflation PSI

 

 

Front Tires

15*

Rear Tires

20*

 

 

6.Work may now be performed on the vehicle. Be sure to properly torque all bolts that were loosened. Wheel bolts should be torqued after the vehicle is lowered to the ground.

7.Lower the vehicle by first jacking the vehicle up high enough to remove the jack stands. Then carefully lower the jack until the vehicle is on the ground.

8.Remove wheel chocks.

.

21350

Figure 6-1

*Maximum tire pressure is noted on tire side wall.

Jacking the Vehicle

!DANGER

For your safety and safety of others, a jacked vehicle must be supported properly with jack stands before working under and around it. Also the wheels on the ground must be chocked on both sides to prevent the vehicle from rolling forward or backward.

IMPORTANT: Use a hydraulic jack, floor jack, or scissor type jack to lift vehicle. Do not use a handyman jack or bumper jack and don’t jack against the bumper, body, differential case, axles or hydraulic lines.

1.Prepare vehicle for maintenance as outlined in steps 1-6 on page 22.

2.Loosen the lug nuts on a wheel being removed approximately 1/2 turn counterclockwise while it is still on the ground.

3.See important note above. Place proper jack under vehicle as follows:

a.Front tires: Refer to Figure 6-1.Place jack under the main frame just behind the axle.

b.Rear tires: Refer to Figure 6-2.Place jack under the main frame just in front of the axle.

4.Jack vehicle only high enough to do the work intended.

5.Support vehicle securely with jack stands before working under and around the vehicle.

21351

Figure 6-2

Shock Absorbers

Shock absorbers are located under the seat to make the ride more comfortable. Traveling fast may cause the shock absorbers to bottom-out making the ride rough.

Electrical System

A 12 volt, 25 amp, negative ground electrical system is provided. The electrical system is protected by a fuse located behind the dash near the key switch and a moisture proof self-resetting circuit breaker in the wiring harness near the starter at the engine. The amp ratings are as follows:

•Fuse behind the dash - 30 Amps

•Self-resetting circuit breaker - 30 Amps

6/30/05

4400EX Heavy Duty Off Road Utility Vehicle 720-051M 23

Page 24 Page 26
Image 25
Page 24 Page 26
Contents Gondo Table of Contents Using This Manual Safety FirstApplication Owner Assistance Land Pride Service Department East North StreetSerial Number Plate Product SupportBe Aware of Signal Words Safety SymbolFor Your Protection Before OperatingTire Safety Practice Safe MaintenancePrepare for Emergencies Wear Protective EquipmentSafe Operating Procedures Table of Contents 818-543C Safety Decals838-492C 838-629C 838-486C 838-490C 838-628C 838-444C Pre-Delivery Certificate Dealer Service and Inspection ListVehicle Information Dealer Test Ride ListCustomer Acceptance List Dealer Delivery To Customer ListOperator Responsibilities Dashboard Switches and InstrumentsGeneral Operation Pre-Start Check ListFoot Operated Controls Hand Operated Controls Fuel IndicatorDriving Conditions Descending Steep Hills Towing the GondoTraverse Traveling on Steep Hills Towing Without a TrailerTraveling Tips From the Trail Masters Table of Contents Gondo Options Gondo AccessoriesRear Cargo Box TiresPrepare Vehicle for Maintenance General MaintenanceTorque Values Jacking the Vehicle Tire MaintenanceShock Absorbers Electrical SystemJump Starting the Battery BatteryPrepare Vehicle to Jump-Start Disconnecting Jumper Cables Connecting Jumper CablesFuel System Fuel Filter and Fuel Line Maintenance Engine MaintenanceFilling the Fuel Tank Emptying the Fuel TankHigh Altitude Carburetor Kit Power Steering BeltPrecleaner Foam Element Air Filter Maintenance SchedulePrecleaner Element 61 mm deep -083-02-S Engine Air FilterSpark Arrester Maintenance Procedure Spark Arrester Maintenance ScheduleReplacement Parts Spark ArresterMaintenance Schedule Engine Oil Engine Oil Maintenance ScheduleEngine Oil Type and Capacity Engine Oil Level Check6mo/100hrs Engine Oil and Filter ChangeDifferential Oil Type and Capacity Differential Maintenance ScheduleDifferential Oil Level Check Differential Oil ChangeBrake Fluid Transmission FluidGrease Type Lubrication Steering & Cargo Lift Cylinder FluidRotating Bearing Surfaces Pillow Block BearingVehicle Storage Preparation Engine Preparation for StorageVehicle Removal From Storage Preparation Short term storage 90 days or lessLight Scuff IntroductionScratch Required Tools and MaterialsDeep Gouge 4400EX Series Specifications and CapacitiesBattery will not charge up Symptoms Probable Causes Suggested Remedies Battery is deadBrakes are sticking won’t release Brakes don’t functionEngine runs unevenly Engine overheatsGear Shift is malfunctioning Engine stops runningPark brake doesn’t work Starter cranks slowlySteering play is excessive Steering does not track correctlyVehicle speed does not reach 17 MPH Vehicle looses ground speed withoutIn-tpi Ft-lb Torque Values ChartTable of Contents Utility Vehicle Land Pride Limited WarrantyCorporate Office P.O. Box 5060 Salina, Kansas 67402-5060 USA

4400ex specifications

The Land Pride 4400EX is a versatile and robust implement that is designed for agricultural operations and landscaping tasks. This exceptional piece of equipment stands out for its functionality and durability, making it an ideal choice for both professional landscapers and property owners seeking high-performance tools for ground preparation and maintenance.

One of the most notable features of the Land Pride 4400EX is its heavy-duty construction. Built with a solid frame, it ensures stability and reliability even in the challenging conditions of rugged terrains. The implement is designed to handle various tasks such as grading, leveling, and creating smooth surfaces, establishing it as a go-to choice for diverse applications.

The 4400EX is equipped with advanced technologies that enhance its operational efficiency. The implement utilizes a precision-engineered quick-attach system, allowing users to swap out attachments quickly and without complications. This feature saves valuable time on the job site and increases overall productivity.

Another highlight is its adjustable blade depth, which provides users with the versatility to achieve the desired finish for different projects. Whether users are working in soft soil or hard packed areas, the Land Pride 4400EX can adapt to the task at hand, ensuring a professional-grade result every time.

The implement is also designed with user comfort in mind. It features ergonomic controls that are easy to access, allowing operators to navigate smoothly through tasks without experiencing fatigue. Additionally, the Land Pride 4400EX is compatible with a variety of tractors, making it a flexible addition to any farming or landscaping arsenal.

Maintenance of the 4400EX is straightforward due to its design, which minimizes wear and tear on components. Regular upkeep helps ensure longevity, allowing users to leverage this equipment for years to come.

In conclusion, the Land Pride 4400EX stands out for its exceptional construction, advanced features, and user-friendly design. Its versatility and robust performance make it an invaluable tool for anyone looking to enhance their productivity in agricultural and landscaping tasks. With a focus on reliability and efficiency, the 4400EX continues to be a favored choice among professionals and enthusiasts alike.
Top Page Image Contents