Land Pride 4400ex manual Engine Maintenance, Filling the Fuel Tank, Emptying the Fuel Tank

Page 28

Table of Contents

Section 6: Maintenance

Filling the Fuel Tank

Refer to Figure 6-4on page 26

The fuel tank is located on the left side under the seat console. Total fuel capacity is 8 gallons.

When filling the fuel tank, place gear shift in 1st or reverse gear, set park brake, turn off engine and remove ignition key. Tilt seat console forward to access fuel tank. Clean dirt from around fuel cap, remove cap and begin filling. When finished, screw cap back on securely and wipe up any spilled gasoline. Use regular unleaded gasoline with an octane rating of 87 or higher.

IMPORTANT: Never use methanol, gasoline containing methanol and/or gasohol containing more than 10% ethanol. These fuels can damage the vehicle’s fuel system. Do not mix oil with gasoline.

Using a fuel stabilizer/conditioner in the vehicle can provide benefits such as:

1.Keeps gasoline fresh during storage of 90 days or less. The fuel tank should be emptied for longer storage.

2.Cleans the engine during operation.

3.Eliminates gum-like varnish build-up in the fuel system.

IMPORTANT: Do not use fuel additives containing methanol or ethanol.

Add the correct amount of gas stabilizer/conditioner to the gas. Follow the gas stabilizer/conditioner manufacturer’s directions for best results.

Emptying the Fuel Tank

!DANGER

Never siphon a fuel tank by sucking on a hose with your mouth. Gasoline is a poison. Also fuel vapors and gas are harmful to your lungs and can permanently damage them. Always use a siphon pump.

The fuel tank will need emptying when preparing for long term storage or replacing a damaged one.

1.Prepare vehicle for maintenance as outlined in steps 1-6 on page 22.

2.Follow all Fuel Safety Cautions, Warnings and Dangers.

3.Remove fuel cap and siphon fuel through the fuel fill opening with a siphon pump into an approved gas container. Make sure the container or containers are capable of holding all the gas. Do not dump fuel on the ground.

Fuel Filter and Fuel Line Maintenance

Refer to Figure 6-4

The fuel filter (Land Pride Part No. 831-031C) is installed in the fuel line between the fuel tank and engine and should be replaced annually. At the same time check the fuel line hoses for any cracks or leaks. Inspect and replace fuel filter and fuel lines as follows:

1.Prepare vehicle for maintenance as outlined in steps 1-6 on page 22.

2.Safely secure the seat console in the raised position.

3.Following all Fuel Safety Cautions and Warnings, remove clamps securing the fuel filter and remove fuel filter for inspection.

4.Check fuel filter for sediment and water accumulation. Check fuel lines for cracks and leaks.

5.Replace damaged fuel lines with new ones.

6.Replace fuel filter when sediment or water is present.

7.Reattach fuel filter to fuel line with arrow on the filter pointing in the same direction fuel flows in the line. Fuel flows towards the engine.

Fuel Cap and

Fuel Fill Opening

Fuel Gauge

Fuel Filter

21441

 

Figure 6-4

8.Install hose clamps around fuel filter.

9.Start vehicle and inspect for fuel leaks along fuel line and fuel filter.

10.Shut off vehicle and remove wheel chocks if used.

Engine Maintenance

General Information

Detailed instructions and recommendations for break-in and regular maintenance are specified in the engine operator’s manual. Engine warranty is backed by the engine manufacturer. Please refer to engine manufacturer’s manual for engine servicing, lubricating oil levels, oil quality and viscosity recommendations, bolt torques, etc. Special attention should be paid to applicable data that is not duplicated here.

26

4400EX Heavy Duty Off Road Utility Vehicle 720-051M

6/30/05

Page 27 Page 29
Image 28
Page 27 Page 29
Contents Gondo Table of Contents Using This Manual Safety FirstApplication Land Pride Service Department East North Street Owner AssistanceSerial Number Plate Product SupportSafety Symbol Be Aware of Signal WordsFor Your Protection Before OperatingPractice Safe Maintenance Tire SafetyPrepare for Emergencies Wear Protective EquipmentSafe Operating Procedures Table of Contents Safety Decals 818-543C838-492C 838-629C 838-486C 838-490C 838-628C 838-444C Dealer Service and Inspection List Pre-Delivery CertificateVehicle Information Dealer Test Ride ListDealer Delivery To Customer List Customer Acceptance ListDashboard Switches and Instruments Operator ResponsibilitiesGeneral Operation Pre-Start Check ListFoot Operated Controls Fuel Indicator Hand Operated ControlsDriving Conditions Towing the Gondo Descending Steep HillsTraverse Traveling on Steep Hills Towing Without a TrailerTraveling Tips From the Trail Masters Table of Contents Gondo Accessories Gondo OptionsRear Cargo Box TiresPrepare Vehicle for Maintenance General MaintenanceTorque Values Tire Maintenance Jacking the VehicleShock Absorbers Electrical SystemJump Starting the Battery BatteryPrepare Vehicle to Jump-Start Disconnecting Jumper Cables Connecting Jumper CablesFuel System Engine Maintenance Fuel Filter and Fuel Line MaintenanceFilling the Fuel Tank Emptying the Fuel TankPower Steering Belt High Altitude Carburetor KitAir Filter Maintenance Schedule Precleaner Foam ElementPrecleaner Element 61 mm deep -083-02-S Engine Air FilterSpark Arrester Maintenance Schedule Spark Arrester Maintenance ProcedureReplacement Parts Spark ArresterMaintenance Schedule Engine Oil Maintenance Schedule Engine OilEngine Oil Type and Capacity Engine Oil Level CheckEngine Oil and Filter Change 6mo/100hrsDifferential Maintenance Schedule Differential Oil Type and CapacityDifferential Oil Level Check Differential Oil ChangeTransmission Fluid Brake FluidSteering & Cargo Lift Cylinder Fluid Grease Type LubricationPillow Block Bearing Rotating Bearing SurfacesEngine Preparation for Storage Vehicle Storage PreparationVehicle Removal From Storage Preparation Short term storage 90 days or lessIntroduction Light ScuffScratch Required Tools and MaterialsDeep Gouge Specifications and Capacities 4400EX SeriesSymptoms Probable Causes Suggested Remedies Battery is dead Battery will not charge upBrakes are sticking won’t release Brakes don’t functionEngine overheats Engine runs unevenlyEngine stops running Gear Shift is malfunctioningPark brake doesn’t work Starter cranks slowlySteering does not track correctly Steering play is excessiveVehicle speed does not reach 17 MPH Vehicle looses ground speed withoutTorque Values Chart In-tpi Ft-lbTable of Contents Land Pride Limited Warranty Utility VehicleCorporate Office P.O. Box 5060 Salina, Kansas 67402-5060 USA

4400ex specifications

The Land Pride 4400EX is a versatile and robust implement that is designed for agricultural operations and landscaping tasks. This exceptional piece of equipment stands out for its functionality and durability, making it an ideal choice for both professional landscapers and property owners seeking high-performance tools for ground preparation and maintenance.

One of the most notable features of the Land Pride 4400EX is its heavy-duty construction. Built with a solid frame, it ensures stability and reliability even in the challenging conditions of rugged terrains. The implement is designed to handle various tasks such as grading, leveling, and creating smooth surfaces, establishing it as a go-to choice for diverse applications.

The 4400EX is equipped with advanced technologies that enhance its operational efficiency. The implement utilizes a precision-engineered quick-attach system, allowing users to swap out attachments quickly and without complications. This feature saves valuable time on the job site and increases overall productivity.

Another highlight is its adjustable blade depth, which provides users with the versatility to achieve the desired finish for different projects. Whether users are working in soft soil or hard packed areas, the Land Pride 4400EX can adapt to the task at hand, ensuring a professional-grade result every time.

The implement is also designed with user comfort in mind. It features ergonomic controls that are easy to access, allowing operators to navigate smoothly through tasks without experiencing fatigue. Additionally, the Land Pride 4400EX is compatible with a variety of tractors, making it a flexible addition to any farming or landscaping arsenal.

Maintenance of the 4400EX is straightforward due to its design, which minimizes wear and tear on components. Regular upkeep helps ensure longevity, allowing users to leverage this equipment for years to come.

In conclusion, the Land Pride 4400EX stands out for its exceptional construction, advanced features, and user-friendly design. Its versatility and robust performance make it an invaluable tool for anyone looking to enhance their productivity in agricultural and landscaping tasks. With a focus on reliability and efficiency, the 4400EX continues to be a favored choice among professionals and enthusiasts alike.
Top Page Image Contents