Land Pride 4400ex manual Power Steering Belt, High Altitude Carburetor Kit

Page 29

Table of Contents

Section 6: Maintenance

High Altitude Carburetor Kit

IMPORTANT: The air-fuel mixture in carburetors modified for high elevation is too lean when operating at elevations below 5,000 feet. Operating engines with modified carburetors below 5,000 feet can result in engine overheating and serious engine damage. Return carburetor to original factory specifications when operating at low elevations.

Gondo vehicles shipped from the factory are equipped with carburetors designed to operate efficiently between 0 and 4,999 feet. Carburetor change over kits for different altitudes may be purchased from your nearest Land Pride Dealer. The following kits are available:

Elevation

Carburetor Kit No.

0’ - 7,999’

Engine Standard

8,000’ & up

24755125-S

Power Steering Shield

21346

Figure 6-5

Refer to Figure 6-5

5. Remove bolts securing belt cover and remove cover.

Power Steering Belt

Refer to Figure 6-5& Figure 6-6

Power steering belt and pump are positioned behind the engine and are protected by a shield. Do not remove shield except to service the belt and always replace shield after servicing the belt.

Replace power steering belt when it shows signs of severe cuts, tears, excessive weather checking and cracking or burns caused by slipping. Slight raveling of belt covering does not indicate failure. Trim ravelings with a sharp knife.

Inspect belt pulley grooves and flanges for wear. A new belt, or one in good condition, should never run against bottom of pulley groove. Replace pulley when this is the case, otherwise belt will lose power and slip excessively.

Never pry a belt to get it on a pulley as this will cut or damage the fibers of the belt covering.

Keep oil and grease away from belts and never use belt dressings. Any of these will destroy the belt composition in a very short time.

!CAUTION

Make certain to keep fingers from getting caught between belt and pulley when rotating belt over pulley.

Replace power steering belt as follows:

1.Prepare vehicle for maintenance as outlined in steps 1-6 on page 22.

2.Safely secure the seat console in the raised position.

3.Disconnect negative battery cable.

4.Safely secure cargo box and seat console in the up position to prevent injury.

Drive Pulley

Take-up Bolt & Slot

Driven Pulley

Power Steering

Pump

21353

Figure 6-6

Refer to Figure 6-6

6.Loosen belt take-up bolt and hand squeeze belt together. This should allow room to remove the belt.

7.Remove belt by rolling it off over the drive pulley and then lifting it up off the driven pulley.

8.Reinstall new belt by placing it over the driven pulley and then rolling it over the drive pulley.

9.Re-tension power steering belt and tighten take-up bolt.

10.Reinstall belt cover and fasteners.

11.Reconnect battery negative cable.

12.Remove blocks securing cargo box up and lower cargo box.

6/30/05

4400EX Heavy Duty Off Road Utility Vehicle 720-051M 27

Image 29
Contents Gondo Table of Contents Application Safety FirstUsing This Manual Owner Assistance Land Pride Service Department East North StreetSerial Number Plate Product SupportBe Aware of Signal Words Safety SymbolFor Your Protection Before OperatingTire Safety Practice Safe MaintenancePrepare for Emergencies Wear Protective EquipmentSafe Operating Procedures Table of Contents 818-543C Safety Decals838-492C 838-629C 838-486C 838-490C 838-628C 838-444C Pre-Delivery Certificate Dealer Service and Inspection ListVehicle Information Dealer Test Ride ListCustomer Acceptance List Dealer Delivery To Customer ListOperator Responsibilities Dashboard Switches and InstrumentsGeneral Operation Pre-Start Check ListFoot Operated Controls Hand Operated Controls Fuel IndicatorDriving Conditions Descending Steep Hills Towing the GondoTraverse Traveling on Steep Hills Towing Without a TrailerTraveling Tips From the Trail Masters Table of Contents Gondo Options Gondo AccessoriesRear Cargo Box TiresTorque Values General MaintenancePrepare Vehicle for Maintenance Jacking the Vehicle Tire MaintenanceShock Absorbers Electrical SystemPrepare Vehicle to Jump-Start BatteryJump Starting the Battery Fuel System Connecting Jumper CablesDisconnecting Jumper Cables Fuel Filter and Fuel Line Maintenance Engine MaintenanceFilling the Fuel Tank Emptying the Fuel TankHigh Altitude Carburetor Kit Power Steering BeltPrecleaner Foam Element Air Filter Maintenance SchedulePrecleaner Element 61 mm deep -083-02-S Engine Air FilterSpark Arrester Maintenance Procedure Spark Arrester Maintenance ScheduleReplacement Parts Spark ArresterMaintenance Schedule Engine Oil Engine Oil Maintenance ScheduleEngine Oil Type and Capacity Engine Oil Level Check6mo/100hrs Engine Oil and Filter ChangeDifferential Oil Type and Capacity Differential Maintenance ScheduleDifferential Oil Level Check Differential Oil ChangeBrake Fluid Transmission FluidGrease Type Lubrication Steering & Cargo Lift Cylinder FluidRotating Bearing Surfaces Pillow Block BearingVehicle Storage Preparation Engine Preparation for StorageVehicle Removal From Storage Preparation Short term storage 90 days or lessLight Scuff IntroductionScratch Required Tools and MaterialsDeep Gouge 4400EX Series Specifications and CapacitiesBattery will not charge up Symptoms Probable Causes Suggested Remedies Battery is deadBrakes are sticking won’t release Brakes don’t functionEngine runs unevenly Engine overheatsGear Shift is malfunctioning Engine stops runningPark brake doesn’t work Starter cranks slowlySteering play is excessive Steering does not track correctlyVehicle speed does not reach 17 MPH Vehicle looses ground speed withoutIn-tpi Ft-lb Torque Values ChartTable of Contents Utility Vehicle Land Pride Limited WarrantyCorporate Office P.O. Box 5060 Salina, Kansas 67402-5060 USA

4400ex specifications

The Land Pride 4400EX is a versatile and robust implement that is designed for agricultural operations and landscaping tasks. This exceptional piece of equipment stands out for its functionality and durability, making it an ideal choice for both professional landscapers and property owners seeking high-performance tools for ground preparation and maintenance.

One of the most notable features of the Land Pride 4400EX is its heavy-duty construction. Built with a solid frame, it ensures stability and reliability even in the challenging conditions of rugged terrains. The implement is designed to handle various tasks such as grading, leveling, and creating smooth surfaces, establishing it as a go-to choice for diverse applications.

The 4400EX is equipped with advanced technologies that enhance its operational efficiency. The implement utilizes a precision-engineered quick-attach system, allowing users to swap out attachments quickly and without complications. This feature saves valuable time on the job site and increases overall productivity.

Another highlight is its adjustable blade depth, which provides users with the versatility to achieve the desired finish for different projects. Whether users are working in soft soil or hard packed areas, the Land Pride 4400EX can adapt to the task at hand, ensuring a professional-grade result every time.

The implement is also designed with user comfort in mind. It features ergonomic controls that are easy to access, allowing operators to navigate smoothly through tasks without experiencing fatigue. Additionally, the Land Pride 4400EX is compatible with a variety of tractors, making it a flexible addition to any farming or landscaping arsenal.

Maintenance of the 4400EX is straightforward due to its design, which minimizes wear and tear on components. Regular upkeep helps ensure longevity, allowing users to leverage this equipment for years to come.

In conclusion, the Land Pride 4400EX stands out for its exceptional construction, advanced features, and user-friendly design. Its versatility and robust performance make it an invaluable tool for anyone looking to enhance their productivity in agricultural and landscaping tasks. With a focus on reliability and efficiency, the 4400EX continues to be a favored choice among professionals and enthusiasts alike.