Kunz C60K, H60T, H60B, E60B G. Drive Belt Removal And Tension, Models H60T & H60H - See Figure

Page 13

G.DRIVE BELT REMOVAL AND TENSION

G.DRIVE BELT REMOVAL AND TENSION

Shut off engine and allow mower blades to stop turning before making any adjustments or repairs.

Remove the safety shields.

Loosen the nuts on the spring-loaded idler; adjust the nut until the belt can be slipped off the idler and drive sheaves.

Slip the belt down under the drive sheave and off the blade spindle sheaves.

Install the new belt and adjust the tension as follows:

Models H60T & H60H: – See Figure 8.

Adjust the spring-loaded idler springs to a compressed length of 15/16” initially for a few hours until the belts run in; then adjust the spring to 1-1/8” to 1-1/4” compressed length.

Initial Spring Length 15/16”	Front
Running Spring Length 1-1/8” to 1-1/4”
	Engine

Figure 8: Belt Pattern and Spring Adjustment (Model H60T & H60H)

Model C60K: – See Figure 9.

Adjust the spring-loaded idler springs to a compressed length of 15/16” initially for a few hours until the belts run in; then adjust the spring to 1-1/8” to 1-1/4” compressed length.

12

Image 13

Contents 60” FINISH CUT With Assembly Instructions For Models C60K, H60T, H60H & E60BOWNER’S MANUAL C60KA. ASSEMBLY OF MOWER WHEELS ASSEMBLY INSTRUCTIONSYou should have Optional hitchesFigure 2 Installation of Caster Support Stop Direct Behind Tongue Position Offset Tongue PositionD. INSTALLATION OF OPTIONAL HITCHES OPERATIONS AND ADJUSTMENTSRead all Owners Manuals before using equipment A. HITCH CONFIGURATIONS Refer to Figure B. ATV TONGUE CONFIGURATIONS Refer to Figure C. ADJUSTING CUTTING HEIGHT D. STARTING ENGINE The engine full speed setting with mower blades running is 3350 RPMFor Model H60H Start engine and move throttle toward slow position to disengage choke For Model H60H Backing up with one wing mower is easy. Backing becomes a greater challenge as additional wing mowers are towed. Avoid backing up by planning ahead. Make loops instead of backing Models H60T & H60H - See Figure G. DRIVE BELT REMOVAL AND TENSIONModel C60K - See Figure For Model E60B - See Figure Sharp blades can cause bodily injury if not handled properly H. MOWER BLADE REMOVAL, BALANCING & INSTALLATIONAlways balance the mower blades each time they are sharpened J. TIRE PRESSURE I. LUBRICATIONK. TRANSPORTATION OF MOWER L. STORAGEDIMENSIONS WING MOWER SPECIFICATIONSModel ENGINEH60H E60BDescription ACREASE WING MOWER PARTS MODEL C60KC60K C60K MODELH60T ACREASE WING MOWER PARTS MODEL H60TH60T E60B ACREASE WING MOWER PARTS MODEL E60BMODEL E60B Quantity ACREASE WING MOWER PARTS MODEL H60HMODEL H60H H60T, E60B & H60H LAWN & GARDEN HITCH PARTSOPTIONAL HITCH PARTS ATV TONGUE PARTSDescription Clean or Replace Any Safety Signs That Are not Readable or Damaged SAFETY SIGNS AND LOCATIONSOPTIONAL FLOATATION KIT OPTIONAL EQUIPMENT