Kunz C60K, H60T, H60B, E60B owner manual For Model E60B - See Figure

Page 14

For Model E60B: - See Figure 10.

Front

Engine

Initial Spring Length 15/16”

Running Spring Length 1-1/8” to 1-1/4”

Figure 9: Belt Pattern and Spring Adjustment (Model C60K)

For Model E60B: - See Figure 10.

With the clutch engaged, adjust the nuts on the spring loaded idler adjuster bolt until the length of the spring is between 2-1/4” and 2-3/8”. This model comes with a belt brake when the clutch is disengaged. This is a safety feature to stop the blades from turning after the clutch is disengaged. To ensure that the brake works properly the spring length must be set correctly. With the clutch disengaged make sure the spring length is no more then 2-3/4”.

The brake stud must be adjusted. If the brake stud is not adjusted correctly, the blades will still spin even though the clutch may be in the disengaged position. Always shut mower engine off before servicing.

To the adjust brake place clutch in the engaged position. Loosen the bolt on the top of the brake stud. Slide the brake stud in the slot until there is about 1/2” of clearance between the belt and the brake stud. Tighten the bolt at the top of the brake stud.

If brake stud is not set in correct position underbraking or overbraking may occur. If overbraking occurs premature belt failure could occur and possible fire due to overheating.

13

Image 14

Contents OWNER’S MANUAL With Assembly Instructions For Models C60K, H60T, H60H & E60B60” FINISH CUT C60KYou should have ASSEMBLY INSTRUCTIONSA. ASSEMBLY OF MOWER WHEELS Optional hitchesFigure 2 Installation of Caster Support Stop Offset Tongue Position Direct Behind Tongue PositionRead all Owners Manuals before using equipment OPERATIONS AND ADJUSTMENTSD. INSTALLATION OF OPTIONAL HITCHES A. HITCH CONFIGURATIONS Refer to Figure B. ATV TONGUE CONFIGURATIONS Refer to Figure C. ADJUSTING CUTTING HEIGHT For Model H60H The engine full speed setting with mower blades running is 3350 RPMD. STARTING ENGINE Start engine and move throttle toward slow position to disengage choke For Model H60H Backing up with one wing mower is easy. Backing becomes a greater challenge as additional wing mowers are towed. Avoid backing up by planning ahead. Make loops instead of backing Model C60K - See Figure G. DRIVE BELT REMOVAL AND TENSIONModels H60T & H60H - See Figure For Model E60B - See Figure Always balance the mower blades each time they are sharpened H. MOWER BLADE REMOVAL, BALANCING & INSTALLATIONSharp blades can cause bodily injury if not handled properly K. TRANSPORTATION OF MOWER I. LUBRICATIONJ. TIRE PRESSURE L. STORAGEModel WING MOWER SPECIFICATIONSDIMENSIONS ENGINEE60B H60HC60K ACREASE WING MOWER PARTS MODEL C60KDescription MODEL C60KACREASE WING MOWER PARTS MODEL H60T H60TH60T ACREASE WING MOWER PARTS MODEL E60B E60BMODEL E60B ACREASE WING MOWER PARTS MODEL H60H QuantityMODEL H60H LAWN & GARDEN HITCH PARTS H60T, E60B & H60HDescription ATV TONGUE PARTSOPTIONAL HITCH PARTS SAFETY SIGNS AND LOCATIONS Clean or Replace Any Safety Signs That Are not Readable or DamagedOPTIONAL EQUIPMENT OPTIONAL FLOATATION KIT