Kunz C60K, H60T, H60B, E60B owner manual C. Adjusting Cutting Height

Page 8
C.ADJUSTING CUTTING HEIGHT

C.ADJUSTING CUTTING HEIGHT

Shut off all engines and allow the mower blades to come to a complete stop on the wing mowers and on the tow vehicle before adjusting the cutting height.

The cutting height can be adjusted in a range from 1.0" to 4.0". This is accomplished by adjusting the height adjusting bolts on each of the four corners of the wing mower. See Figure 7. Turn the bolts clockwise to raise the mower cutting height and counter-clockwise to lower the mower cutting height.

When more than one mower is used at a time, it is very important to have all the mowers adjusted as close to the same cutting height as possible to obtain a high quality cutting job.

Adjust the mowers as follows:

1.Pull the mowing unit on to a smooth, level surface.

2.Adjust the tow vehicle mower deck (If applicable) to the desired cutting height and level both fore and aft and side to side.

3.Measure the distance from the level surface to the mower blade cutting edge on the tow vehicle.

Shut off tow vehicle engine and allow mower blades to stop completely before attempting to measure the cutting height.

Adjust for Upper or Lower Cutting Range

Mower Blade

Lower Edge

of Deck

Adjust Anti-Scalp Wheels Under Deck to the Upper or Lower Cutting Range

Measure the Distance

 

and Add 5/16” to get

5/16”

Cutting height

Height Adjustment Bolts

Snug 4 Bolts to

Eliminate Side

Movement

Cutting Height

Smooth Surface

Figure 7: Adjusting Wing Mower Cutting Height

7

Page 7 Page 9
Image 8
Page 7 Page 9
Contents With Assembly Instructions For Models C60K, H60T, H60H & E60B 60” FINISH CUTOWNER’S MANUAL C60KASSEMBLY INSTRUCTIONS A. ASSEMBLY OF MOWER WHEELSYou should have Optional hitchesFigure 2 Installation of Caster Support Stop Offset Tongue Position Direct Behind Tongue PositionRead all Owners Manuals before using equipment OPERATIONS AND ADJUSTMENTSD. INSTALLATION OF OPTIONAL HITCHES A. HITCH CONFIGURATIONS Refer to Figure B. ATV TONGUE CONFIGURATIONS Refer to Figure C. ADJUSTING CUTTING HEIGHT For Model H60H The engine full speed setting with mower blades running is 3350 RPMD. STARTING ENGINE Start engine and move throttle toward slow position to disengage choke For Model H60H Backing up with one wing mower is easy. Backing becomes a greater challenge as additional wing mowers are towed. Avoid backing up by planning ahead. Make loops instead of backing Model C60K - See Figure G. DRIVE BELT REMOVAL AND TENSIONModels H60T & H60H - See Figure For Model E60B - See Figure Always balance the mower blades each time they are sharpened H. MOWER BLADE REMOVAL, BALANCING & INSTALLATIONSharp blades can cause bodily injury if not handled properly I. LUBRICATION J. TIRE PRESSUREK. TRANSPORTATION OF MOWER L. STORAGEWING MOWER SPECIFICATIONS DIMENSIONSModel ENGINEE60B H60HC60K ACREASE WING MOWER PARTS MODEL C60KDescription MODEL C60KACREASE WING MOWER PARTS MODEL H60T H60TH60T ACREASE WING MOWER PARTS MODEL E60B E60BMODEL E60B ACREASE WING MOWER PARTS MODEL H60H QuantityMODEL H60H LAWN & GARDEN HITCH PARTS H60T, E60B & H60HDescription ATV TONGUE PARTSOPTIONAL HITCH PARTS SAFETY SIGNS AND LOCATIONS Clean or Replace Any Safety Signs That Are not Readable or DamagedOPTIONAL EQUIPMENT OPTIONAL FLOATATION KIT
Top Page Image Contents