Kunz C60K, H60T, H60B, E60B owner manual Offset Tongue Position, Direct Behind Tongue Position

Page 4
Offset Tongue Position

5.The telescoping hitch can either be installed to the left or right and should clear the back of the tire by about 2”.

6.If one mower is pulled on both the left and right side of the tow vehicle, then one telescoping hitch can be mounted to the left and one to the right.

Adjust Stop Bolt to

Back of Tow Vehicle

Telescoping Hitch - Install to Left

 

 

or to Right or in Both Directions

 

Hitch Stop Angle

When Pulling Two Wing Mowers.

 

 

 

Figure 3: Installation of Tow Vehicle Hitch

Screw Pin

 

 

 

Hitch Pivot – Attach

Tongue

 

 

 

 

 

 

Shackle Clevis

to either Left or Right

 

 

 

 

 

 

 

Caster Assy.

 

 

 

Offset Tongue Position

Direct Behind Tongue Position

Figure 4. Assembly of Hitch Pivot and Tongue

3

Image 4
Contents With Assembly Instructions For Models C60K, H60T, H60H & E60B 60” FINISH CUTOWNER’S MANUAL C60KASSEMBLY INSTRUCTIONS A. ASSEMBLY OF MOWER WHEELSYou should have Optional hitchesFigure 2 Installation of Caster Support Stop Offset Tongue Position Direct Behind Tongue PositionD. INSTALLATION OF OPTIONAL HITCHES OPERATIONS AND ADJUSTMENTSRead all Owners Manuals before using equipment A. HITCH CONFIGURATIONS Refer to Figure B. ATV TONGUE CONFIGURATIONS Refer to Figure C. ADJUSTING CUTTING HEIGHT D. STARTING ENGINE The engine full speed setting with mower blades running is 3350 RPMFor Model H60H Start engine and move throttle toward slow position to disengage choke For Model H60H Backing up with one wing mower is easy. Backing becomes a greater challenge as additional wing mowers are towed. Avoid backing up by planning ahead. Make loops instead of backing Models H60T & H60H - See Figure G. DRIVE BELT REMOVAL AND TENSIONModel C60K - See Figure For Model E60B - See Figure Sharp blades can cause bodily injury if not handled properly H. MOWER BLADE REMOVAL, BALANCING & INSTALLATIONAlways balance the mower blades each time they are sharpened I. LUBRICATION J. TIRE PRESSUREK. TRANSPORTATION OF MOWER L. STORAGEWING MOWER SPECIFICATIONS DIMENSIONSModel ENGINEE60B H60HDescription ACREASE WING MOWER PARTS MODEL C60KC60K MODEL C60KACREASE WING MOWER PARTS MODEL H60T H60TH60T ACREASE WING MOWER PARTS MODEL E60B E60BMODEL E60B ACREASE WING MOWER PARTS MODEL H60H QuantityMODEL H60H LAWN & GARDEN HITCH PARTS H60T, E60B & H60HOPTIONAL HITCH PARTS ATV TONGUE PARTSDescription SAFETY SIGNS AND LOCATIONS Clean or Replace Any Safety Signs That Are not Readable or DamagedOPTIONAL EQUIPMENT OPTIONAL FLOATATION KIT