INSTALLATION
INSTALL THE TOWER
Locate the pin at the bottom left corner of the tower Insert this pin into the bottom left corner hole in the mounting frame bracket Now line up the hole at the top left corner of the tower with the slotted hole in the mounting frame, and thread a 3/7inch bolt through the mounting frame and into the tower Securely wrench tighten the bolt
Route the tower cable through the large hole in the mounting frame Snap the tower cable modular plug into the corresponding jack of the control box Install the large strain relief bushing over the tower cable, and insert it into the large mounting frame hole
NOTE: National Electrical Code requires that you permanently separate the high7 and low7voltage cables
Route the waterfall light wires through the small
hole in the back of the mounting frame Connect the waterfall light wire connectors to the transformer terminals - white to white; black to black Install the small strain relief bushing over the waterfall light wires, and insert it into the small mounting frame hole
Securely handtighten the tower union nut to the mounting frame union Be sure the union O7ring is in place
Carefully pivot the tower closed Line up the holes at the top and bottom right corners of the tower with the slotted holes in the mounting frame Thread a 3/7inch bolt through the mounting frame and into the tower at the top and bottom Tighten the bolts securely, but do not overtighten
You will water test and inspect the tower and mounting frame later, so you may want to only install and handtighten one of the required bolts at this time Both bolts will need to be securely tightened later
11347727AA (A) | 22 | Kohler Co, Kohler, WI |