Kohler 116347-2 manual Wiring Connections, Suction Assembly

WIRING CONNECTIONS

WARNING: Risk of electrical shockTo ￿ reduce the risk of electric shock￿ connect only to a properly grounded￿ grounding:type receptacle￿ protected by a ￿round:￿ault Circuit:Interrupter ￿￿￿CI￿￿ Do not remove the plug￿s grounding pin￿ Do not use a grounding adapter￿

The Kohler Custom BodySpa is equipped with a cord and plug￿ All wiring of the pump has been completed at the factory￿ A licensed electrician

will need to install a ￿￿CI:protected￿ 120 V￿ 20 A￿ grounded outlet￿ The electrician must install the outlet behind the BodySpa￿ and within 24:inches

of the pump￿ No other load should be on this circuit￿

SUCTION ASSEMBLY

DESIGN GUIDE

The purpose of the suction bracket is to position the suction housing at the correct installation height￿

and to provide the installer with a means of securing the suction housing in place during final assembly￿ Do not remove the suction fitting from the

bracket

assembly￿

You can locate the suction along any wall of the

Custom BodySpa room within 48:inches of the

pump box￿ as long as

the

overall

wall

thickness

will

not

exceed

1:3/4:inches￿

Plan

to

provide

access

to

the

suction

assembly in

case

servicing

is

needed￿

The suction location must allow the installer

to

route straight lengths of 1:1/2:inch ￿I￿D￿￿ rigid PVC

tubing￿ with no vertical

elbows

inline

to

trap

water￿

from the suction housing to

the

pump

inlet￿

You

can

use

a

90:degree

elbow

at

a

wall corner

if the suction

is

located

on a

different

wall

than

the

pump

box￿

NOTE: Refer to the minimum waterline height information on the side of the pump box to determine the maximum pump box height needed for the pump to prime effectively￿

Plan to apply a minimum 1/4:inch per foot pitch toward the suction housing to provide adequate water drainage through the suction line￿

116347:2:AA ￿A￿ 5 Kohler Co￿￿ Kohler￿ WI