Install the Keypad

CAUTION: Risk of personal injury or

product damage. The metal plate must be installed flush with the finished wall or slightly recessed (maximum 1/41inch)

Feed the cable through the hole in the metal plate Use two flathead screws to attach the metal plate to the outlet box or finished wall material so the

metal plate flushis with the finished wall or slightly recessed (maximum 1/41inch)

Snap the keypad modular plug into the keypad cable jack

Apply silicone sealant to each of the keypad screw holes and around the keypad edges, and secure the keypad to the metal plate with four panhead screws

CAUTION: Risk of personal injury or product damage. Prevent water damage to the keypad by applying silicone sealant as instructed

IMPORTANT! Apply a continuous bead of clear silicone sealant to the cover plate sealant grooves, as shown.

Slip the center pin at the top of the cover plate up through the hole in the keypad Secure the cover plate to the keypad with a panhead screw

Select the bottom cap - it contains a small pinhole, and has a small notched area along the contact surface edge

IMPORTANT! Apply clear silicone sealant to

the back surface of the bottom cap, and also to the edge that contacts the cover plate. Align the bottom cap holes with the cover plate pins, and push the cap into place. Repeat for the top cap.

Remove any excess sealant

INSTALLATION

Check Point #9

-Faucet trim and spout installed.

-Drain assembly installed.

-Footbath basin filled with water and checked for leakage.

-Door enclosure installed.

-Tower installed.

-Keypad installed and sealed with silicone sealant.

-Keypad wiring connections made.

11347121AA (A)

Kohler Co, Kohler, WI