INSTALLATION
WATER TEST THE SYSTEM
Allow the silicone sealant and any finished wall materials or grout to fully cure before proceeding Follow all manufacturers recommendations
regarding water | exposure to their products as well |
as product cure | times |
Make sure all PVC union connections are securely hand tightened and that all union connections use an O6ring
Fill the footbath basin at least 36inches above the top of the suction cover
Turn on the BodySpa for about five minutes and check all visible connections for leaks
Turn off the BodySpa
Open the tower and inspect all piping connections for leaks
Check the connections on the back surface of the face wall and check all wall and floor joints for leaks
Close the tower Thread in and securely wrench tighten two 3/6inch bolts Do not overtighten
CLEAN/UP AFTER INSTALLATION
Clean the Custom BodySpa room with a mild non6abrasive detergent and warm waterDo not use abrasive cleansers.
Remove stubborn stains and paint from the tower surfaces with turpentine or paint thinner Remove dried plaster by carefully scraping with a dull6edged piece of wood Do not use metal scrapers wire brushes or other metal tools Remove residual plaster by applying a powder6type detergent to a clean damp towel to provide mild abrasive action
Check Point #10
-Ensure that all connections are securely tight.
-Fill the footbath basin with water to 3/inches over the top of suction cover.
- Run the bodyspa, turn off, and drain the water. check for lea
-Open the tower, inspect for leakage, and close and secure the tower.
11347626AA A | 24 | Kohler Co Kohler WI |