Jonsered SM 2055 E, SM 2186 Chain oil tank FIG, Vibration damping plate for the chain saw FIG

Page 11

DESCRIPTION

Chain oil tank (FIG. 5)

Chain sawmill with electric motor

On the saw carriage for sawmills that are fitted with an electric motor, the oil tank (25) for chain oil is located on the electric motor. The chain oil is pumped via a hose by a chain oil pump that is installed under the clutch drum in the console. The pump supplies the bar with chain oil when the sawmill is running.

Motor console for electric motor (FIG. 6)

The chain sawmill with electric motor is fitted with a console in which the motor, transmission and bar are installed. The console is installed in the saw carriage and is adjusted vertically with the idler adjustment screw. The console runs on skid rails with adjustable plastic guides.

Vibration damping plate for the chain saw (FIG. 7)

The chain saw is secured in a vibration-free plate (9) that is screwed into the saddle. The vibration-free plate is supplied with an adjustment option, where the position of the saw in relation to the rails can be adjusted. The saddle is installed in the saw carriage and is adjusted vertically with an idler adjustment screw.

Bar and chain (FIG. 7)

The bar and chain (A) are installed on the engine console (electric sawmill) and installed on the chain saw in accordance with the chain saw’s operator’s manual. The bar has the same mounting on both the sawmill with the chain saw and the electric saw mill.

Feed unit for chain sawmill with electric motor (FIG. 8)

The feed unit (A) is installed in the left-hand end of the rail profile and is connected to the saw carriage by a cable. The chain is started from the feed unit and the feeding speed can be controlled variably.

FIG. 5

25

FIG. 6

FIG. 7

A

9

FIG. 8

A

English – 11

Page 10 Page 12
Image 11
Page 10 Page 12
Contents SM 2186 SM 2055 E Table of Contents Introduction IntroductionSymbols KEY to SymbolsPersonal Protective Equipment Safety RegulationsSafety Regulations Risk Zone One-man Sawmill Safety EquipmentFuel Safety Safety During UseOne-man sawmill chain saw engine DescriptionOne-man Sawmill Electric Motor One-man sawmill with electric motor and feed Handlebars FIG Height Setting FIGSaw carriage FIG Frame and FIGFeed unit for chain sawmill with electric motor FIG Chain oil tank FIGVibration damping plate for the chain saw FIG Bar and chain FIGElectric motor feed unit FIG MotorsChain saw engine FIG Electric Motor FIGFolding Stops C Height Adjustment BRails Log Bolsters aRail Guard Adjustable Support FeetRail Stop Safety Devices Unpacking InstallationInstallation Installation SiteSaw Carriage Adjustment FIG Setting up the Saw Carriage FIGOne-man sawmill with electric motor Install chain saw and bar FIGInstall the bar FIG One-man sawmill with chain saw engineInstall throttle and cable FIG Install scale pointer and scale FIGInstall the handlebar FIG Checking the bar Adjusting the barPetrol Fuel HandlingFuel chain saw engine Fuelling Two-stroke oilMixing Stopping the chain saw engine FIG Starting and StoppingStarting a cold chain saw engine FIG Starting the electric sawmill with feed FIG Starting the electric sawmill FIGSecuring the Log USESawing Calculating the YieldStarting the Electric Motor Starting the Petrol EngineEdging FIG Clutch drum MaintenanceSaw chain Drive belt Saw unit’s height adjustmentMonthly maintenance MaintenanceDaily maintenance Weekly maintenanceTechnical data Technical DataEU Declaration of Conformity only applies to Europe Noise LevelsVibration Levels Page 2003W50 108 89
Top Page Image Contents