Jonsered SM 2055 E, SM 2186 manual Starting and Stopping, Starting a cold chain saw engine FIG

Page 23

STARTING AND STOPPING

!WARNING!

Observe the following before star- ting the engine:

•The engine must be mounted in the sawmill before starting. Otherwise the clutch can come loose and cause personal injuries.

•Keep people and animals well away from the risk zone.

Starting a cold chain saw engine (FIG. 38)

A cold engine is started as follows:

1.Read through the operator’s manual for the chain saw carefully and make sure you understand it before attempting to start the chain saw.

2.Set the stop button to the start position.

3.Pull out the choke. When the choke is pulled out the throttle valve is automatically set in the start throttle position.

4.For other operation, see the chain saw operator’s manual.

FIG. 38

Stopping the chain saw engine (FIG. 39)

The engine is stopped by setting the stop button to the stop position.

FIG. 39

English – 23

Image 23

Contents SM 2186 SM 2055 E Table of Contents Introduction IntroductionSymbols KEY to SymbolsPersonal Protective Equipment Safety RegulationsSafety Regulations Risk Zone One-man Sawmill Safety EquipmentFuel Safety Safety During UseOne-man sawmill chain saw engine DescriptionOne-man Sawmill Electric Motor One-man sawmill with electric motor and feed Handlebars FIG Height Setting FIGSaw carriage FIG Frame and FIGFeed unit for chain sawmill with electric motor FIG Chain oil tank FIGVibration damping plate for the chain saw FIG Bar and chain FIGElectric motor feed unit FIG MotorsChain saw engine FIG Electric Motor FIGFolding Stops C Height Adjustment BRails Log Bolsters aRail Guard Adjustable Support FeetRail Stop Safety Devices Unpacking InstallationInstallation Installation SiteSaw Carriage Adjustment FIG Setting up the Saw Carriage FIGOne-man sawmill with electric motor Install chain saw and bar FIGInstall the bar FIG One-man sawmill with chain saw engineInstall throttle and cable FIG Install scale pointer and scale FIGInstall the handlebar FIG Checking the bar Adjusting the barPetrol Fuel HandlingFuel chain saw engine Fuelling Two-stroke oilMixing Stopping the chain saw engine FIG Starting and StoppingStarting a cold chain saw engine FIG Starting the electric sawmill with feed FIG Starting the electric sawmill FIGSecuring the Log USESawing Calculating the YieldStarting the Electric Motor Starting the Petrol EngineEdging FIG Clutch drum MaintenanceSaw chain Drive belt Saw unit’s height adjustmentMonthly maintenance MaintenanceDaily maintenance Weekly maintenanceTechnical data Technical DataEU Declaration of Conformity only applies to Europe Noise LevelsVibration Levels Page 2003W50 108 89