Jonsered SM 2186, SM 2055 E manual KEY to Symbols

Page 4

KEY TO SYMBOLS

Symbols

The symbols below are used in this operator’s manual.

Eye protection and hearing protection should be used.

Boots or work shoes with

steel toecaps and non-slip soles should

be worn.

Eye protection should be used.

Protective gloves should be worn.

Switch off the engine by moving

the stop switch to the STOP position before carrying out any checks or maintenance.

Warning Signs

The decal with the symbols below is found on the one- man sawmill.

Eye protection and hearing protection should be used.

Protective gloves should be worn.

Boots or work shoes with steel toecaps and non-slip soles should be worn.

Read this manual carefully and make sure you understand it before attempting to use the one- man sawmill.

Exercise caution.

4 – English

Image 4

Contents SM 2186 SM 2055 E Table of Contents Introduction IntroductionKEY to Symbols SymbolsSafety Regulations Safety RegulationsPersonal Protective Equipment One-man Sawmill Safety Equipment Fuel SafetySafety During Use Risk ZoneDescription One-man sawmill chain saw engineOne-man Sawmill Electric Motor One-man sawmill with electric motor and feed Height Setting FIG Saw carriage FIGFrame and FIG Handlebars FIGChain oil tank FIG Vibration damping plate for the chain saw FIGBar and chain FIG Feed unit for chain sawmill with electric motor FIGMotors Chain saw engine FIGElectric Motor FIG Electric motor feed unit FIGHeight Adjustment B RailsLog Bolsters a Folding Stops CRail Stop Adjustable Support FeetRail Guard Safety Devices Installation InstallationInstallation Site UnpackingSetting up the Saw Carriage FIG Saw Carriage Adjustment FIGInstall chain saw and bar FIG Install the bar FIGOne-man sawmill with chain saw engine One-man sawmill with electric motorInstall the handlebar FIG Install scale pointer and scale FIGInstall throttle and cable FIG Adjusting the bar Checking the barFuel chain saw engine Fuel HandlingPetrol Mixing Two-stroke oilFuelling Starting a cold chain saw engine FIG Starting and StoppingStopping the chain saw engine FIG Starting the electric sawmill FIG Starting the electric sawmill with feed FIGUSE Securing the LogCalculating the Yield SawingStarting the Petrol Engine Starting the Electric MotorEdging FIG Maintenance Clutch drumSaw chain Saw unit’s height adjustment Drive beltMaintenance Daily maintenanceWeekly maintenance Monthly maintenanceTechnical Data Technical dataVibration Levels Noise LevelsEU Declaration of Conformity only applies to Europe Page 108 89 2003W50