Jonsered SM 2055 E, SM 2186 manual Starting the Petrol Engine, Starting the Electric Motor

Page 27

USE

!WARNING!

Check during sawing that the chain does not hit the folding stops or log lock.

!WARNING!

The saw carriage must not be moved backwards while the chain is in motion. The log could come loose and cause personal injury.

Starting the Petrol Engine

1.Start the engine. See page 23.

Starting the Electric Motor

1.Start the electric motor. See page 24.

Sawing

2.Move the saw carriage forwards and cut off the sapwood.

3.Remove the sapwood.

4.Loosen the log, turn it 180°, lower the height adjuster (B), and secure the log.

5.Set the required cutting height using the height adjustment crank (11). This determines the width of the board.

6.Cut off the sapwood on the other side. See p 2 and 3.

FIG. 47

FIG. 48

English – 27

Image 27

Contents SM 2186 SM 2055 E Table of Contents Introduction IntroductionSymbols KEY to SymbolsSafety Regulations Safety RegulationsPersonal Protective Equipment Risk Zone One-man Sawmill Safety EquipmentFuel Safety Safety During UseOne-man sawmill chain saw engine DescriptionOne-man Sawmill Electric Motor One-man sawmill with electric motor and feed Handlebars FIG Height Setting FIGSaw carriage FIG Frame and FIGFeed unit for chain sawmill with electric motor FIG Chain oil tank FIGVibration damping plate for the chain saw FIG Bar and chain FIGElectric motor feed unit FIG MotorsChain saw engine FIG Electric Motor FIGFolding Stops C Height Adjustment BRails Log Bolsters aAdjustable Support Feet Rail StopRail Guard Safety Devices Unpacking InstallationInstallation Installation SiteSaw Carriage Adjustment FIG Setting up the Saw Carriage FIGOne-man sawmill with electric motor Install chain saw and bar FIGInstall the bar FIG One-man sawmill with chain saw engineInstall scale pointer and scale FIG Install the handlebar FIGInstall throttle and cable FIG Checking the bar Adjusting the barFuel Handling Fuel chain saw enginePetrol Two-stroke oil MixingFuelling Starting and Stopping Starting a cold chain saw engine FIGStopping the chain saw engine FIG Starting the electric sawmill with feed FIG Starting the electric sawmill FIGSecuring the Log USESawing Calculating the YieldStarting the Electric Motor Starting the Petrol EngineEdging FIG Clutch drum MaintenanceSaw chain Drive belt Saw unit’s height adjustmentMonthly maintenance MaintenanceDaily maintenance Weekly maintenanceTechnical data Technical DataNoise Levels Vibration LevelsEU Declaration of Conformity only applies to Europe Page 2003W50 108 89