Jonsered SM 2186, SM 2055 E manual Rail Stop, Adjustable Support Feet, Rail Guard

Page 14

DESCRIPTION

Rail Stop

Rail stops are fitted at the ends of the rails (A). The stop is mounted using a bolt from the side of the rail.

Adjustable Support Feet

Adjustable support feet are mounted by each log bolster. You can fine tune the rails’ adjustment using the support feet.

Rail Guard

The saw carriage is equipped with four rail guards that run above the rails. The rail guards have the tasks of keeping the rails clean and preventing crush injuries between the runner wheels and rails.

FIG. 14

FIG. 15

FIG. 16

14 – English

Image 14

Contents SM 2186 SM 2055 E Table of Contents Introduction IntroductionKEY to Symbols SymbolsPersonal Protective Equipment Safety RegulationsSafety Regulations Safety During Use One-man Sawmill Safety EquipmentFuel Safety Risk ZoneDescription One-man sawmill chain saw engineOne-man Sawmill Electric Motor One-man sawmill with electric motor and feed Frame and FIG Height Setting FIGSaw carriage FIG Handlebars FIGBar and chain FIG Chain oil tank FIGVibration damping plate for the chain saw FIG Feed unit for chain sawmill with electric motor FIGElectric Motor FIG MotorsChain saw engine FIG Electric motor feed unit FIGLog Bolsters a Height Adjustment BRails Folding Stops CRail Guard Adjustable Support FeetRail Stop Safety Devices Installation Site InstallationInstallation UnpackingSetting up the Saw Carriage FIG Saw Carriage Adjustment FIGOne-man sawmill with chain saw engine Install chain saw and bar FIGInstall the bar FIG One-man sawmill with electric motorInstall throttle and cable FIG Install scale pointer and scale FIGInstall the handlebar FIG Adjusting the bar Checking the barPetrol Fuel HandlingFuel chain saw engine Fuelling Two-stroke oilMixing Stopping the chain saw engine FIG Starting and StoppingStarting a cold chain saw engine FIG Starting the electric sawmill FIG Starting the electric sawmill with feed FIGUSE Securing the LogCalculating the Yield SawingStarting the Petrol Engine Starting the Electric MotorEdging FIG Maintenance Clutch drumSaw chain Saw unit’s height adjustment Drive beltWeekly maintenance MaintenanceDaily maintenance Monthly maintenanceTechnical Data Technical dataEU Declaration of Conformity only applies to Europe Noise LevelsVibration Levels Page 108 89 2003W50