Jonsered SM 2055 E, SM 2186 manual Maintenance, Clutch drum

Page 29

MAINTENANCE

!WARNING!

The one-man sawmill must be disconnected from power during all maintenance work. Always use personal protective equipment.

Clutch drum

When replacing the clutch drum on the chain saw, see the chain saw operator’s manual.

The clutch drum on the chain sawmill with electric motor has a setscrew installed in the end of the drive shaft. The task of the screw is to prevent the clutch drum from unscrewing in the event the sawmill is started in the wrong direction. CAUTION! The screw and its washer must be unscrewed before the clutch drum can be removed. The clutch drum has left-hand threads.

The clutch drum is equipped with ring sprockets (replaceable). The clutch drum has a needle bearing on the output shaft, which has to be greased regularly (once a week). CAUTION! Use only high quality bearing grease.

FIG. 52

FIG. 53

English – 29

Image 29

Contents SM 2186 SM 2055 E Table of Contents Introduction IntroductionSymbols KEY to SymbolsPersonal Protective Equipment Safety RegulationsSafety Regulations Fuel Safety One-man Sawmill Safety EquipmentSafety During Use Risk ZoneOne-man sawmill chain saw engine DescriptionOne-man Sawmill Electric Motor One-man sawmill with electric motor and feed Saw carriage FIG Height Setting FIGFrame and FIG Handlebars FIGVibration damping plate for the chain saw FIG Chain oil tank FIGBar and chain FIG Feed unit for chain sawmill with electric motor FIGChain saw engine FIG MotorsElectric Motor FIG Electric motor feed unit FIGRails Height Adjustment BLog Bolsters a Folding Stops CRail Guard Adjustable Support FeetRail Stop Safety Devices Installation InstallationInstallation Site UnpackingSaw Carriage Adjustment FIG Setting up the Saw Carriage FIGInstall the bar FIG Install chain saw and bar FIGOne-man sawmill with chain saw engine One-man sawmill with electric motorInstall throttle and cable FIG Install scale pointer and scale FIGInstall the handlebar FIG Checking the bar Adjusting the barPetrol Fuel HandlingFuel chain saw engine Fuelling Two-stroke oilMixing Stopping the chain saw engine FIG Starting and StoppingStarting a cold chain saw engine FIG Starting the electric sawmill with feed FIG Starting the electric sawmill FIGSecuring the Log USESawing Calculating the YieldStarting the Electric Motor Starting the Petrol EngineEdging FIG Clutch drum MaintenanceSaw chain Drive belt Saw unit’s height adjustmentDaily maintenance MaintenanceWeekly maintenance Monthly maintenanceTechnical data Technical DataEU Declaration of Conformity only applies to Europe Noise LevelsVibration Levels Page 2003W50 108 89