ASSEMBLY
UNPACKING
This product requires assembly.
Carefully cut the box down the sides then remove the machine and any accessories from the box. Make sure that all items listed in the packing list are included.
NOTE: This machine is heavy and requires a minimum of two people to lift. To avoid back injury, lift with your legs and not your back.
WARNING:
Do not use this product if any parts on the Packing List are already assembled to your product when you unpack it. Parts on this list are not assembled to the product by the manufacturer and require customer installation. Use of a product that may have been improperly assembled could result in serious personal injury.
Inspect the unit carefully to make sure no damage oc- curred during shipping.
Do not discard the packing material until you have
carefully inspected and satisfactorily operated the product.
If any parts are damaged or missing, please call
PACKING LIST
See Figure 2.
The following items are included with the generator:
Key |
|
|
No. | Description | Qty. |
1 | Wheels | 2 |
2 | Axle | 2 |
3 | Washer | 2 |
4 | Lanyard and Handle Lock Pin | 1 |
5 | Bottle of Engine Lubricant | 1 |
6 | Handle | 1 |
7 | Bolts | 2 |
8 | Nuts | 2 |
| Operator’s Manual (not shown) | 1 |
WARNING:
If any parts are damaged or missing do not operate this product until the parts are replaced. Use of this product with damaged or missing parts could result in serious personal injury.
WARNING:
Do not attempt to modify this product or create acces- sories not recommended for use with this product. Any such alteration or modification is misuse and could result in a hazardous condition leading to possible serious per- sonal injury.
WARNING:
Do not attempt to operate the generator until assembly is complete. Failure to comply could result in possible serious personal injury.
TOOLS NEEDED
See Figure 3.
The following tools (not included or drawn to scale) are needed for assembly:
Socket Wrench (12 mm and 13 mm)
Combination Wrench (10 mm, 12 mm, 13 mm, and 14 mm)
NOTE: Do not put fuel or lubricant in the generator before installing the wheels and handle.
INSTALLING THE WHEELS
See Figure 4.
Wheels are provided to assist in moving the generator to the desired location.
nLocate the axle, washer, and wheels.
Slide the axle through the hole in the center of the wheel then slide the washer onto the axle.
nLift the machine and slide the axle into the wheel mount- ing hole in the machine base as shown.
nPush the wheel into the hole until it clicks in place and is secured properly.
Repeat the process on the other side to install second wheel.
INSTALLING THE HANDLE
See Figures 5 - 6.
Slide the handle into bracket and secure in place using bolts and nuts.
Attach the lanyard to the handle lock pin and the handle as shown.
Insert the pin through the hole in the handle and the generator frame to secure handle in place.
WARNING:
Do not attempt to lift the unit by the handle assembly. If it is necessary to lift the generator, always grasp by the frame. Use proper lifting techniques to avoid back injury.
Page 11 — English