Harrington Hoists TCR Piping, Hoses And Fittings, 1Diagram of Air Supply Configuration Typical

Page 13

3.6.1 CAUTION

3.4.2The filter servicing the hoist can also service other hoists and air consuming equipment. In this case, the air filter must be in sized for the total air consumption of the equipment it is servicing.

3.5 Air Dryer - CAUTION To prevent corrosion and hoist malfunction, employ an air dryer in the air supply system to ensure that dry air is supplied to the hoist. If there is moisture in the air supplied to the hoist, this moisture will cause corrosion on internal hoist components during periods when the hoist is idle leading to hoist malfunction.

3.6Piping, Hoses And Fittings

System Configuration - The system should be configured as shown in Figure 3-1. Since moisture tends to accumulate in compressed air systems, corrosion may result if the system is not periodically drained.

Arrange for a drain in the air supply piping at the lowest point in the piping, and

Periodically drain the system to remove moisture/water from the system and to prevent corrosion. Filter, regulator (if equipped), and lubricator must be arranged in the order shown in Figure 3-2.

Figure 3-1Diagram of Air Supply Configuration (Typical)

Figure 3-2Typical Air Supply Filter, Regulator and Lubricator.

13

Image 13

Contents EFFFECTIVEMay1,1,20006 AIR Powered Chain Hoist TCR SeriesTable of Contents Section Terms and Summary Important Information and WarningsPage Page 1Warning Tag Attached to Air Hoist Pendant Model Cord 1Hoist Specifications SpecificationsTechnical Information Dimensions Part Names 4Top and Bottom Hook DimensionPage Air Supply System Requirements Preoperational ProceduresAir Supply Capacity And Regulation LubricationPiping, Hoses And Fittings 1Diagram of Air Supply Configuration Typical1Air Supply Pipe and Hose Sizes Mounting Location Connecting Hoist to Air SupplyMounting the Hoist Preoperational Checks and Trial Operation Non-Stationary Application6Capsized Hook and Chain Page Introduction OperationShall’s and Shall Not’s for Operation 1Pendant Control Hoist ControlsCord Control Adjusting the ControlsOperation of the Load Limiter General InspectionInspection Classification Periodic Inspection Frequent Inspection1Frequent Inspection 2Periodic InspectionInspection Records Occasionally Used HoistsInspection Methods and Criteria 3Hoist Inspection Methods and Criteria ActionSee Sections Suspension housing, chain attachments, clevises TCR10000C2 TCR10000P2 Figure NoHoists Parts View Recorded Dimension Maximum/Minimum Value 6Top Hook & Bottom Hook DimensionsFor Replacement Air Hoist Lubrication LubricationLoad Chain Lubrication Hooks and Suspension ComponentsLoad Limiter Maintenance and HandlingBrake Load Chain Replacement3Diagram showing chain replacement 4Pendant Hose and Strain Relief Connections PendantStorage Outdoor Installation1Troubleshooting Guide Symptom Cause Remedy Troubleshooting1Troubleshooting Guide Symptom Cause Remedy Warranty TCR Nameplate Parts InformationPage Page Harrington Hoists, Inc Harrington Hoists Western Division