Harrington Hoists TCR owner manual

Page 5

WARNING

Equipment described herein is not designed for and MUST NOT be used for lifting, supporting, or transporting people, or for lifting or supporting loads over people.

Equipment described herein should not be used in conjunction with other equipment unless necessary and/or required safety devices applicable to the system, crane, or application are installed by the system designer, system manufacturer, crane manufacturer, installer, or user.

Modifications to upgrade, rerate, or otherwise alter this equipment shall be authorized only by the original equipment manufacturer.

Equipment described herein may be used in the design and manufacture of cranes or monorails. Additional equipment or devices may be required for the crane and monorail to comply with applicable crane design and safety standards. The crane designer, crane manufacturer, or user is responsible to furnish these additional items for compliance. Refer to ANSI/ASME B30.17, “Safety Standard for Top-Running Single Girder Cranes”; ANSI/ASME B30.2 “Safety Standard for Top-Running Double-Girder Cranes”; and ANSI/ASME B30.11 “Safety Standard for Underhung Cranes and Monorails”.

If a below-the-hook lifting device or sling is used with a hoist, refer to ANSI/ASME B30.9, “Safety Standard for Slings” or ANSI/ASME B30.20, “Safety Standard for Below-the-Hook Lifting Devices”.

Hoists, trolleys and cranes, used to handle hot molten material may require additional equipment or devices. Refer to ANSI Z241.2, “Safety Requirements for Melting and Pouring of Metals in the Metalcasting Industry”.

Failure to read and comply with any one of the limitations noted herein can result in serious bodily injury or death, and/or property damage.

5

Page 4 Page 6
Image 5
Page 4 Page 6
Contents EFFFECTIVEMay1,1,20006 AIR Powered Chain Hoist TCR SeriesTable of Contents Section Terms and Summary Important Information and WarningsPage Page 1Warning Tag Attached to Air Hoist Technical Information SpecificationsPendant Model Cord 1Hoist Specifications Dimensions Part Names 4Top and Bottom Hook DimensionPage Air Supply System Requirements Preoperational ProceduresAir Supply Capacity And Regulation LubricationPiping, Hoses And Fittings 1Diagram of Air Supply Configuration Typical1Air Supply Pipe and Hose Sizes Mounting the Hoist Connecting Hoist to Air SupplyMounting Location Preoperational Checks and Trial Operation Non-Stationary Application6Capsized Hook and Chain Page Introduction OperationShall’s and Shall Not’s for Operation 1Pendant Control Hoist ControlsCord Control Adjusting the ControlsOperation of the Load Limiter Inspection Classification InspectionGeneral Periodic Inspection Frequent Inspection1Frequent Inspection 2Periodic InspectionInspection Records Occasionally Used HoistsInspection Methods and Criteria 3Hoist Inspection Methods and Criteria ActionSee Sections Suspension housing, chain attachments, clevises TCR10000C2 TCR10000P2 Figure NoFor Replacement 6Top Hook & Bottom Hook DimensionsHoists Parts View Recorded Dimension Maximum/Minimum Value Air Hoist Lubrication LubricationLoad Chain Lubrication Hooks and Suspension ComponentsLoad Limiter Maintenance and HandlingBrake Load Chain Replacement3Diagram showing chain replacement 4Pendant Hose and Strain Relief Connections PendantStorage Outdoor Installation1Troubleshooting Guide Symptom Cause Remedy Troubleshooting1Troubleshooting Guide Symptom Cause Remedy Warranty TCR Nameplate Parts InformationPage Page Harrington Hoists, Inc Harrington Hoists Western Division
Top Page Image Contents