Guardian Technologies 04759-2 Generac Power Systems Two Year Limited Warranty For Guardian

Page 56
GENERAC POWER SYSTEMS "TWO YEAR" LIMITED WARRANTY FOR GUARDIAN®

Section 10 – Warranty

Air-cooled 7 kW, 12 kW and 15 kW Generators

GENERAC POWER SYSTEMS "TWO YEAR" LIMITED WARRANTY FOR GUARDIAN®

"PREPACKAGED EMERGENCY AUTOMATIC STANDBY GENERATORS"

For a period of two years from the date of original sale, Generac Power Systems, Inc. (Generac) warrants that its Guardian generator will be free from defects in material and workmanship for the items and period set forth below. Generac will, at its option, repair or replace any part which, upon examination, inspection and testing by Generac or a Guardian Authorized Warranty Service Dealer, is found to be defective. Any equipment that the purchaser/owner claims to be defective must be examined by the nearest Guardian Authorized Warranty Service Dealer. All transportation costs under the warranty, including return to the factory, are to be borne and prepaid by the purchaser/owner. This warranty applies only to Generac Guardian prepackaged emergency automatic standby generators sold and rated for use in "Standby" applications.

WARRANTY SCHEDULE

YEARS ONE and TWO - 100% (one hundred percent) transferable coverage on Labor and Part(s) listed (proof of purchase and main- tenance is required):

Engine - All Components Alternator - All Components Transfer System - All Components

Steel enclosures are warranted against rusting for the first year of ownership only. Damage caused after receipt of generator is the responsibility of the owner and is not covered by this warranty. Nicks, scrapes, dents or scratches to the painted enclosure should be repaired promptly by the owner.

All warranty expense allowances are subject to the conditions defined in Guardian's Warranty Policies, Procedures and Flat Rate Manual.

THIS WARRANTY SHALL NOT APPLY TO THE FOLLOWING:

Guardian generators that utilize non-Guardian/Generac replacement parts.

Guardian generators utilizing non-Guardian/Generac automatic transfer switches.

Repairs or diagnostics performed by individuals other than Guardian/Generac authorized dealers not authorized in writing by Generac Power Systems.

Any Guardian generators used as rental or trailer mounted applications.

Units used for prime power in place of existing utility power where utility power is present or in place of utility power where utility power service does not normally exist.

Costs of normal maintenance, adjustments, installation and start-up.

Steel enclosures that are rusting due to the improper installation, location in a harsh or saltwater environment or scratched where integrity of paint applied is compromised.

Failures caused by any contaminated fuels, oils, coolants or lack of proper fluid amounts.

Failures due, but not limited, to normal wear and tear, accident, misuse, abuse, negligence or improper installation. As with all mechanical devices, the Generac engines need periodic part(s) service and replacement to perform well. This warranty will not cover repair when normal use has exhausted the life of a part(s) or engine.

Failures caused by any external cause or act of God, such as collision, theft, vandalism, riot or wars, nuclear holocaust, fire, freezing, lightning, earthquake, windstorm, hail, volcanic eruption, water or flood, tornado or hurricane.

Damage related to rodent and/or insect infestation.

Products that are modified or altered in a manner not authorized by Generac in writing.

Any incidental, consequential or indirect damages caused by defects in materials or workmanship, or any delay in repair or replacement of the defective part(s).

Failure due to misapplication.

Telephone, cellular phone, facsimile, internet access or other communication expenses.

Living or travel expenses of person(s) performing service, except as specifically included within the terms of a specific unit warranty period.

Expenses related to "customer instruction" or troubleshooting where no manufacturing defect is found.

Rental equipment used while warranty repairs are being performed.

Costs incurred for equipment used for removal and/or reinstallation of generator, (i.e.; cranes, hoists, lifts, etc.)

Overnight freight costs for replacement part(s).

Overtime labor.

Starting batteries, fuses, light bulbs and engine fluids.

THIS WARRANTY IS IN PLACE OF ALL OTHER WARRANTIES, EXPRESSED OR IMPLIED. SPECIFICALLY, GENERAC MAKES NO OTHER WARRANTIES AS TO THE MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE. Some states do not allow limitations on how long an implied warranty lasts, so the above limitation may not apply to you.

GENERAC'S ONLY LIABILITY SHALL BE THE REPAIR OR REPLACEMENT OF PART(S) AS STATED ABOVE. IN NO EVENT SHALL GENERAC BE LIABLE FOR ANY INCIDENTAL OR CONSEQUENTIAL DAMAGES, EVEN IF SUCH DAMAGES ARE A DIRECT RESULT OF GENERAC'S NEGLIGENCE. Some states do not allow the exclusion or limitation of incidental or consequential damages, so the above limitation may not apply to you.

This warranty gives you specific legal rights. You also have other rights from state to state.

GENERAC® POWER SYSTEMS, INC.

P.O. BOX 297 WHITEWATER, WI 53190

Revision (02/01/05)

Part No. 0F3985

Revision C (08/12/05)

Printed in U.S.A.

Image 56
Contents Models 04758-2 6 kW NG, 7 kW LP 04759-2 12 kW NG, 12 kW LP 04760-2 13 kW NG, 15 kW LPThis manual should remain with the unit  Not intended for use as Primary Power in place of utility ‹ CONTENTS ‹ OPERATION AND MAINTENANCE‹ HOW TO OBTAIN SERVICE INTRODUCTIONSection 2 - Post Installation Start-up and AdjustmentsSection 4 - Maintenance Section 5 - Troubleshooting GENERAL HAZARDS  IMPORTANT SAFETY INSTRUCTIONS WARNING  This product contains or emits chemicals ELECTRICAL HAZARDS   FIRE HAZARDS  EXPLOSION HAZARDS  ‹ STANDARDS INDEX1.1 UNPACKING/INSPECTION 1.2 PROTECTION SYSTEMS1.3 SYSTEM SET LED DANGERFigure 1.2 - 12 kW/15 kW, V-twin GT-990/760 Engine 1.4 THE GENERATORFigure 1.1 - 7 kW, Single Cylinder GH-410 Engine ‹ 1.5.2 ENGINE 1.5 SPECIFICATIONS‹ 1.5.1 GENERATOR 1.8 RECONFIGURING THE FUEL SYSTEM 1.6 FUEL REQUIREMENTS AND RECOMMENDATIONS1.7 FUEL CONSUMPTION DANGER1.9 LOCATION ‹ 1.8.2 12KW AND 15KW, 990CC ENGINES‹ 1.9.1 GENERATOR Figure 1.4 - Demand Regulator1.10 BATTERY INSTALLATION 1.11 THE BATTERY‹ 1.9.2 TRANSFER SWITCH 1.9.2.1 7 kW, 12 kW and 15 kW Units Figure 1.5 - Battery Cable Connections2.2 CHECK TRANSFER SWITCH OPERATION 2.1 BEFORE INITIAL START-UP2.3 ELECTRICAL CHECKS Section 2 - Post Installation Start-up and Adjustments2.4 GENERATOR TESTS UNDER LOAD 2.5 CHECKING AUTOMATIC OPERATIONFigure 2.1 - Dual Fuel Regulators 2.6 ADJUSTING THE REGULATOR NATURAL GAS ONLYFigure 2.2 - Placement of Regulator 2.7 ENGINE GOVERNOR ADJUSTMENT Figure 2.3 - Single Cylinder Engine Governor AdjustmentFigure 2.4 - V-twin Engine Governor Adjustment Figure 2.5 - V-twin Full Load Speed Adjust Screw2.8 VOLTAGE REGULATOR ADJUSTMENT 3.1 BREAK-IN PROCEDUREFigure 2.6 - Voltage Adjustment Potentiometer ‹ 3.2.1 “AUTO” POSITION3.3 AUTOMATIC TRANSFER OPERATION 3.4 SEQUENCE OF AUTOMATIC OPERATION3.5 MANUAL TRANSFER OPERATION ‹ 3.5.1 TRANSFER TO GENERATOR POWER SOURCE3.6 SETTING THE EXERCISE TIMER ‹ 3.5.2 TRANSFER BACK TO UTILITY POWER SOURCE‹ 3.7.1 LOW OIL PRESSURE SWITCH Figure 3.2 - Manual Transfer Switch Operation‹ 3.7.2 HIGH TEMPERATURE SWITCH Figure 3.3 - Low Oil Pressure and High Temperature Switches4.1 FUSE 4.2 CHECKING THE ENGINE OIL LEVEL4.5 CHANGING THE ENGINE AIR CLEANER ‹ 4.3.2 OIL CHANGE PROCEDURE4.3 CHANGING THE ENGINE OIL 4.4 CHANGING THE OIL FILTER4.7 BATTERY MAINTENANCE Figure 4.6 - 7 kW, Engine Air Cleaner LocationFigure 4.7 - 12 kW and 15 kW Engine Air Cleaner Figure 4.8 - Setting the Spark Plug Gap4.9 COOLING SYSTEM 4.8 ADJUSTING VALVE CLEARANCEFigure 4.10 - Valve Clearance Adjustment 4.12 OUT OF SERVICE PROCEDURE ‹ 4.12.1 REMOVAL FROM SERVICE‹ 4.12.2 RETURN TO SERVICE 4.10 ATTENTION AFTER SUBMERSIONbe performed by the nearest Authorized Dealer 4.13 SERVICE SCHEDULEATTENTION It is recommended that all service work 5.1 TROUBLESHOOTING GUIDE ProblemCause CorrectionENGINE WIRING Section 6 - Electrical DataCONNECTION CONTROL PANEL BOXCUSTOMER Electrical Schematic - 12 & 15 kW - Drawing No. 0D8501-B Section 6 - Electrical Data ENGINE WIRING Section 6 - Electrical DataCUSTOMER 225A 224AElectrical Schematic - 7 kW - Drawing No. 0D9014-C Section 7 - Exploded Views and Parts Lists PRE PACKAGED UNITS ONLYPART NO. QTY. DESCRIPTION CLOTH, HARDWARE 266.7mm x 146mm 7KWFOAM, EXHAUST SIDE ENCLOSURE FRONT FOAM, BACK EXHAUST ENCLOSURE COVERSection 7 - Exploded Views and Parts Lists PART NO. QTY DESCRIPTIONViews and Parts Lists 66 2, 5, 19, 20, 39, 40, 47, 64, 93 67 8, 11, 12 68 4, 569 16A, 16B, 17 72 27, 28 73 3, 32, 33, 34, 35, 36, 40ASSEMBLY, CRANKCASE HOUSING WITH ASSEMBLY, CRANKSHAFT HORIZONTALITEM PART NO. QTY. DESCRIPTION ROLLER BEARING, GOVERNOR PLATESection 7 - Exploded Views and Parts Lists ASSY, IGNITION COIL GV-990 CYLINDER 7 kW Generator - Drawing No. 0D3504-E 1.8 FT 1.25 FT12 kW and 15 kW Generator - Drawing No. 0D3417-L 32 311.44 FT 2.6 FT3 FT Section 7 - Exploded Views and Parts Lists Section 7 - Exploded Views and Parts Lists DESCRIPTIONSection 7 - Exploded Views and Parts Lists Section 7 - Exploded Views and Parts Lists DESCRIPTIONSection 7 - Exploded Views and Parts Lists Section 7 - Exploded Views and Parts Lists ALL DIMENSIONS IN MILLIMETERS INCHES Section 8 - MountingDrawing No Air-cooledSection 9 - Notes YOUR WARRANTY RIGHTS AND OBLIGATIONS MANUFACTURER’S EMISSION CONTROL SYSTEM WARRANTY COVERAGEPURCHASER’S/OWNER’S WARRANTY RESPONSIBILITIES CALIFORNIA AND FEDERAL EMISSION CONTROL WARRANTY STATEMENTEMISSION CONTROL SYSTEM WARRANTY EMISSION RELATED PARTS INCLUDE THE FOLLOWINGGENERAC POWER SYSTEMS TWO YEAR LIMITED WARRANTY FOR GUARDIAN WARRANTY SCHEDULETHIS WARRANTY SHALL NOT APPLY TO THE FOLLOWING PREPACKAGED EMERGENCY AUTOMATIC STANDBY GENERATORS