Section 3
INSULATION RESISTANCE TESTS
EFFECTS OF DIRT AND MOISTURE
Moisture and dirt are harmful to the continued good operation of any generator set.
If moisture is allowed to remain in contact with the Stator and Rotor windings, some of the moisture will be retained in voids and cracks of the winding insula- tion. This will result in a reduced insulation resistance and, eventually, the unit's AC output will be affected.
Insulation used in the generator is moisture resistant. However, prolonged exposure to moisture will gradu- ally reduce the resistance of the winding insulation.
Dirt can enhance the problem, since it tends to hold moisture into contact with the windings. Salt, as from sea air, contributes to the problem since salt can absorb moisture from the air. When salt and moisture combine, they make a good electrical conductor.
Due to the detrimental affects of dirt and moisture, the generator should be kept as clean and as dry as pos- sible. Rotor and Stator windings should be tested periodically with an insulation resistance tester (such as a megohmmeter or
If the insulation resistance is excessively low, drying may be required to remove accumulated moisture. After drying, perform a second insulation resistance test. If resistance is still low after drying, replacement of the defective Rotor or Stator may be required.
FOLLOW THE TESTER MANUFACTURER'S INSTRUCTIONS CAREFULLY. USE COMMON SENSE TO AVOID DANGEROUS ELECTRICAL SHOCK
DRYING THE GENERATOR
GENERAL:
If tests indicate the insulation resistance of a winding is below a safe value, the winding should be dried before operating the generator. Some recommended drying procedures include (a) heating units and (b) forced air.
HEATING UNITS:
If drying is needed, the generator can be enclosed in a covering. Heating units can then be installed to raise the temperature about
FORCED AIR:
Portable forced air heaters can be used to dry the generator. Direct the heated air into the generator’s air intake openings. Remove the voltage regulator and run the unit at
INSULATION RESISTANCE TESTERS
Figure 3-1 shows one kind of hi-pot tester. The tester shown has a “Breakdown” lamp that will glow during the test procedure to indicate an insulation break- down in the winding being tested.
Figure 3-1. – One Type of Hi-Pot Tester
DANGER! INSULATION RESISTANCE TESTERS SUCH AS
CLEANING THE GENERATOR
GENERAL:
The generator can be cleaned properly only while it is disassembled. The cleaning method used should be determined by the type of dirt to be removed. Be sure to dry the unit after it has been cleaned.
NOTE: A shop that repairs electric motors may be able to assist you with the proper cleaning of gen- erator windings. Such shops are often experi- enced in special problems such as a sea coast environment, marine or wetland applications, mining, etc.
USING SOLVENTS FOR CLEANING:
If dirt contains oil or grease a solvent is generally required. Only petroleum distillates should be used to clean electrical components. Recommended are safety type petroleum solvents having a flash point greater than 100° F. (38° C.).
CAUTION!: Some generators may use epoxy or polyester base winding varnishes. Use sol- vents that will not attack such materials.
Use a soft brush or cloth to apply the solvent. Be careful to avoid damage to wire or winding insulation. After cleaning, dry all components thoroughly using
Page 12