Marantz SR7002 manual Listening to XM Satellite Radio, Selecting AN Input Source, Signal Marginal

ENGLISH

LISTENING TO XM SATELLITE RADIO

SELECTING AN INPUT SOURCE

Before you can listen to XM Satellite Radio, you must first select the input source on the unit.

CHECKING THE XM SIGNAL STRENGTH			3.	Adjust the antenna location until signal strength
AND RADIO ID
				is good.
			4.
				Select channel 0 (XM000) with the 3 or 4
				cursor buttons of the unit or the SCAN + or
	OFF ON/OFFON			SCAN – buttons of the remote controller.
		POWER

SWITCHING XM INFORMATION IN THE FRONT PANEL DISPLAY

You can display XM information (such as artist name/ song title, category or signal status) for the channel currently selected in the front panel display.

1.

AV SURROUND RECEIVER SR8002

USE PAGE 1

TV DVD VCR

TUNER CD CD-R

TAPE AUX1 AUX2

LIGHT

1

RC8001SR

Learning Remote Controller

M

D1

D2

D3

D4

D5

DSS

MD

AMP

2

2.

2.

1.

SOURCE M2. 4.

					D1			POWER
						R8002	OFF		ON
								ON/OFF
					D2
					D3			SOURCE
							SURROUND
							DIGITAL			4.
							AAC		M
					D4
						1.
									D2
USE	PAGE	2	3	4	D5				D1
									D3	4.

D4

USE PAGE 2

D5

1. Press the > button until PAGE 3 is displayed.

2. Press the D1 (DISP) button four times to display the signal status on the front display of

POWER

OFF ON/OFF

SOURCE

USE PAGE 2 3 4

ON

M

D1

D2

D3

D4

D5

2.

1.

2.

the unit.

• The Radio ID is displayed.

X M O O O R A D I O I D

AV SURROUND RECEIVER SR8002

S I G N A L :

(Using the unit)

•The display changes as shown below according to the receiving condition.

SIGNAL: ■■■■■■

SIGNAL: STRONG

(Signal strength is good)

SIGNAL: ■■■■

SIGNAL: MARGINAL

Note:

•If “ANTENNA” appears in the front panel display, the XM Mini-Tuner and Home Dock may not be connected to the XM terminal on the rear panel of this unit properly.

1. Press the > button until PAGE 3 is displayed.

2. Select the information with the DISP (D1) button.

Channel number/name

Artist name/Song title

Channel category

Signal Status

1. Turn the INPUT SELECTOR knob to select “TUNER”.

2. Press the BAND button to select either XM or DAB.

(Using the remote controller)

1. To select tuner, Press the TUNER button twice within two seconds on the remote controller.

2. Press the > button until PAGE 1 is displayed. Select XM or DAB with the D3 button.

(Signal strength is Marginal)

SIGNAL: ■■

SIGNAL: WEAK (Signal strength is poor)

XM NO SIGNAL

SIGNAL: NON

(Loss of the signal)

When the Channel number/name mode is displayed:

X M O 4 0 : D e e p T r c

4 0 : D e e p T r a c k s

(If text is more than 13 characters long, the text is scrolled.)

74