Generac Power Systems 009600-5, 009734-5 owner manual Compartment Floor Cutout

Page 27

Section 6 – Installation

PRIMEPACT 66G and 66LP Recreational Vehicle Generators

•

Vapor seal all compartment seams and joints.

Figure 6.7 – Typical Noise Abatement

•

Over the galvanized steel lining, install a combination

of acoustical materials as mentioned in Section 6.2.3.

To prevent fire or explosion, do not install any insulation or other absorbent materials on the interior or underside of the compartment floor.

• Seal all compartment door edges to prevent noise leakage around the door perimeter.

• Line the compartment door interior (except for air openings) with suitable, fireproof sound insulation (such as 1-inch (25 mm) thick fiberglass with a 2- pound density).

Figure 6.8 — Compartment Floor Cutout

Generac® Power Systems, Inc. 25

Image 27

Contents Power SYSTEMS, INC Introduction Authorized Service Dealer LocationTable of Contents General Hazards Electrical Hazards Reference Number Identification Generator IdentificationGenerator AC Connection System InstallationSafety Generator ApplicabilityEngine OIL Requirements SpecificationsFuel Consumption gph/lbs.ph Fuel RequirementsGenerator Control Panel Optional Remote START/STOP Panel Automatic ChokeBefore Starting the Engine Letting the Engine Stabilize Stopping the GeneratorStarting the Generator Engine Exhaust GASField Boost High Temperature SwitchLOW OIL Pressure Switch Protection Systems5 25-HOUR BREAK-IN Period Checking the Engine OIL LevelOvervoltage Protection 6 25-HOUR CHECK-UPMaintaining the Engine AIR Cleaner Cleaning the Foam PrecleanerChanging the Engine OIL AND/OR OIL Filter Clean AIR Intake Screen Checking the Engine Spark PlugSpark Arrestor Muffler Every SIX Months Cleaning the GeneratorBattery Maintenance WeeklyWattage Reference Guide OUT of Service ProcedureDrive Belt Exercising the GeneratorPrimepact 66G and 66LP Recreational Vehicle Generators Part General Hazards Electrical Hazards Generator Engine Operating Speed Purpose and Scope Installation InstructionsStandards Booklets Equipment DescriptionMajor Features and Dimensions Suspended Mounting Location and SupportGenerator Support Generator LocationCompartment Size Generator CompartmentsGenerator Restraint Compartment ConstructionAcoustics Sound Insulating MaterialsCompartment Floor Cutout Generator Airflow Cooling and Ventilating AIRCompartment Floor Cutouts Cooling AIR Inlet OpeningsTesting the Installation Gasoline Fuel SystemCompensating for Restrictions LP GAS Fuel System Generator Fuel Supply LineParts not Included in Fuel System Gaseous Carburetion Primary RegulatorSome Important Considerations Vapor WithdrawalLeakage Tests Exhaust SystemFuel Supply Lines Excess Flow ValveType of Exhaust System Exhaust System SafetyWiring Electrical ConnectionsBattery Installation 18 Transfer Switch Isolation Method Battery CablesRemote Panel Models Optional AccessoriesBattery Cable Connections Battery CompartmentInitial Start Post Installation TestsTesting Under Load Before Initial START-UPInstallation Checklist Problem Cause Correction Troubleshooting GuideGenerac Power Systems, Inc Electrical Data Exploded Views and Parts Lists QTY Description To Engine BASE, Mounting To Engine BASE, Mounting To Engine Ground Item Part NO. QTY. Description Exploded Views and Parts Lists QTY Description Exploded Views and Parts Lists Carburetor Assemby CARB. V-TWIN L/P Primepact 66G and 66LP Recreational Vehicle Generators Primepact 66G and 66LP Recreational Vehicle Generators Primepact 66G and 66LP Recreational Vehicle Generators Your Warranty Rights and Obligations MANUFACTURER’S Emission Control System Warranty CoveragePURCHASER’S/OWNER’S Warranty Responsibilities Emission Related Parts Include the Following Emission Control System WarrantyGenerac Power SYSTEMS, INC