Dimension One Spas Dynamic Massage Sequencer Temperature Pads, Program Pad, Heat Status Light

	2002 Dimension One Spas Export Owner’s Manual
Control		Function
3		3. LIGHT Pad and Status Light Push the LIGHT pad once to activate the
		brightest setting (Status Light will illuminate, 1). A second push will activate the
		medium setting and a third push will activate the dimmest setting. Push the
		LIGHT pad a fourth time to turn off the light. The light will automatically turn
		off after one hour.
		NOTE: If the Dynamic L.E.D. Light is installed, the low, medium, and high
		settings are disabled. The Light pad turns the Dynamic L.E.D. Light on and off.
4		4.TEMPERATURE Pads
		Pushing the UP (+) pad increases the temperature and pushing the DOWN (-)
		pad decreases the temperature. Push the respective pad one time for each
		degree of temperature change, or push and hold the pad for rapid adjustment.
		The actual hot tub water temperature will remain in the Digital Display
		window until a temperature pad is pushed. When the UP or DOWN pad is
		pushed the Digital Display will indicate the new temperature setting, with the
		SET POINT Icon on the right side of the Digital Display. Once the new
		temperature is set, the actual hot tub water temperature will again be
		indicated. The hot tub will heat to the pre-set temperature automatically.
5		5. PROGRAM Pad
		The PROGRAM pad is used for several different functions including: Clock Set,
		Filter Cycle Start Time, Filter Cycle Duration, Number of Filter Cycles, and
		Temperature Unit Selection. The paragraphs following this table will explain
		how these features are set.
		To initiate the programming sequence at any time, push and hold the
		PROGRAM pad for 3 seconds. If, within 60 seconds, you do not proceed with
		the hot tub programming, the hot tub will automatically exit the programming
		sequence and revert to the previous settings. To exit the programming
		sequence at any time, do not press any pad for 10 seconds. Any programming
		changes made up to that point will be saved.
6		6. Dimension One Spas ICON (Logo)
		The time of day can be viewed by pushing the Dimension One Spas ICON logo
		on the far right of the control. If no other pad is pushed within 5 seconds, the
		display will revert to the hot tub water temperature reading. The pre-set
		factory default is Fahrenheit.
		Pressing the logo for 5 seconds will place the spa in the “Standby” mode and
		allow the spa to be cleaned without turning off the power.
7		7. Heat Status Light
		This Light is illuminated whenever the heater is on.

8