Dimension One Spas Dynamic Massage Sequencer manual Ice, Cooling

2002 Dimension One Spas Export Owner’s Manual

Ice

When “ICE CONDITION” and the water temperature are displayed on the Digital Display, the air temperature in the equipment can has gone below a factory-preset level, and the system has activated “Smart Winter Mode.” It will then automatically activate the pump(s) to circulate water. This is a normal hot tub function. No corrective action is necessary. This feature protects the spa from freezing.

Cooling

When “COOLING” and the water temperature are displayed on the Digital Display, the water temperature has reached 2° F (1.1° C) above the set temperature. The circulation pump and ozone generator will turn off to allow the water to cool back to the set temperature. This is a normal hot tub function. No corrective action is necessary.

The circulation pump and ozone generator will be on while either jet pump is on and they will remain on for 30 minutes after the pump(s) turn off regardless of the water temperature.

Note

The Dimension One Spas Scrolling Message Center will keep all programming for 40 years with no power supply and the time of day for 30 days. This battery back up will not provide power to heat or operate the hot tub.

Note

Summer Mode

The “SUMMER MODE” feature temporarily disables the circulation pump “Cool Off” cycle. During hot weather the spa can experience “Heat Creep”. Heat creep is caused when the spa, during normal maintenance operations, cannot dissipate more heat than is generated. This may cause the spa temperature to exceed the set temperature and cause a “Cool Off” cycle. In order to prevent the water from becoming cloudy due to the circulation pump being turned off by the “Cool Off” cycle, the spa can be set to bypass the “Cool Off” cycle. This is accomplished by setting the spa in the “SUMMER MODE”. To initiate a “SUMMER MODE”, use the Up and Down pads to set the temperature to 59° F (15° C). The Digital Display will indicate “SUMMER MODE”. In this mode the pump will run continuously until the water temperature reaches 107°F (41.67° C) and then turns off. It will remain off until the water temperature reaches 102° F (38.39° C) at which point the pump turns on.

Standby Mode

The “STANDBY” mode allows the user to clean the filter without turning off power to the spa. This feature disables all automatic and manual functions.

To enter the “STANDBY” mode press and hold the Dimension One Spa”s ICON logo for 5 seconds. To exit the mode, press and hold the logo for 5 seconds. If you do not exit the mode manually, the spa will automatically return to normal functionality after 24 hours.

The “Smart Winter” mode is not affected by the use of the “Standby”: mode.

Note

15