Dimension One Spas Dynamic Massage Sequencer Digital Display LCD, Jets 1 and 2 Pads, Light Pad

		2002 Dimension One Spas Export Owner’s Manual
Top Side Control
	Control		Function
	1		1. Digital Display (LCD)
			The Digital Display continuously shows the operating status of the hot tub, as
			well as the various monitoring functions, self-diagnostics, and programming
			information.
	2		JETS 1 and 2 Pads (1)
			When either JETS pad is pushed, the corresponding spa jet pump is energized,
			the respective Digital Display indicator light will be illuminated, the pump speed
			will be indicated on the lower left of the Digital Display and a rotating swirl icon
			will be displayed in the upper left corner of the Digital Display. The rotation
			speed of the swirl will vary according to the pump’s speed. The first time a JETS
			pad is pushed the respective pump will turn on. When the same pad is pushed
			again, the pump will turn off.
			Each time a JETS pad is pushed it will activate a programmable, automatic shut-off
			cycle. The default time is 30 minutes. A progress bar for each pump will indicate
			the time remaining before the pump will turn off. This auto shut-off cycle is a
			safety device and also allows for convenient filtration immediately after use of the
			hot tub
	3		3.LIGHT Pad (1)
			Push LIGHT pad once to activate the brightest setting. A second push will
			activate medium setting and a third push will activate the dimmest setting. A
			message indicating current light intensity will scroll twice on the bottom left of
			the Digital Display (i.e. LIGHT HIGH, LIGHT MEDIUM, LIGHT LOW) and an
			animated icon, with zero, three or six dots around it indicating the light’s
			intensity will be displayed. Push the LIGHT pad a fourth time to turn off the light.
			The light will automatically turn off after one hour.
			NOTE: If the optional Dynamic L.E.D Light is installed, the low, medium and
			high settings are disabled. The Light pad turns the Dynamic L.E.D Light on and
			off.
	4		4. TEMPERATURE Pad
			When the Up or Down pad is pushed to change the set temperature, the
			bottom left of the Digital Display will read “SET TEMP TO _ _ _° F”. When there
			is a call for heat, the Heat Status Light and Digital Display will turn on when the
			heater engages. This is a normal function. The right side of the Digital Display will
			read the current temperature and the bottom left will read “HEATING TO _ _
			_° F” until the hot tub reaches the set temperature. If the water reaches 2° F (-
			16.6° C) (above the set temperature, the message “COOLING TO _ _ _ - CIRC
			PUMP & O3 OFF” will be displayed in the bottom left hand side of the Digital
			Display and a cooling cycle will start.

12