Compaq 326817-003 manual Switch Settings, Setting the Scsi ID, Scsi Jumper Pins, Bit

Installation 2-3

Setting the SCSI ID

Each SCSI device on the same SCSI bus must have a unique SCSI ID. Use the jumper block located on the back of the DAT AutoLoader to set the SCSI ID. For SCSI ID jumper settings see Table 2-2.

Table 2-2

SCSI Jumper Pins

SCSI ID	Bit 2	Bit 1	Bit 0
0	0	0	0
1	0	0	1
2	0	1	0
3	0	1	1
4	1	0	0
5	1	0	1
6	1	1	0
7*	1	1	1

Note: SCSI ID 7 is reserved for the SCSI controller.

Switch Settings

When the DAT AutoLoader is powered on, it reads a set of configuration switches on the underside of the drive. See the following sections for switch descriptions and settings.