Compaq 326817-003 manual Installing the DAT AutoLoader without drive rails

Installation 2-7

2.Connect the SCSI signal cable and the power cable (supplied). (See Figure 2-5.)

3.Carefully slide the DAT AutoLoader the remainder of the way in, adjusting the connecting cables if needed to allow the AutoLoader to be fully inserted.

4.Insert two screws in the front plate using a Torx-15 screwdriver.

To install the Autoloader without drive rails:

1.Remove all screws from drive rails using a Torx-15 screwdriver.

2.Slide the AutoLoader partially into an available removable media bay.

Figure 2-4. Installing the DAT AutoLoader without drive rails

3.Connect the SCSI signal cable and the power cable (supplied). (See Figure 2-5.)

4.Carefully slide the DAT AutoLoader the remainder of the way in, adjusting the connecting cables if needed to allow the AutoLoader to be fully inserted.

5.Use the screws that were removed from the drive rails and insert two of them into the threaded mounting holes on each side.

NOTE: Some drives may not be accessible on both sides. Secure the sides that are accessible.