Compaq 326817-003 manual Connecting the Tabletop AutoLoader

Installation 2-9

Connecting the Tabletop AutoLoader

For the tabletop DAT AutoLoader, follow the procedures below to connect to a Compaq computer:

1.Set the SCSI ID using the switch at the rear of the DAT AutoLoader (See Figure 2-6). The SCSI ID switch can be adjusted by using a pencil or similar object to click the “+” and “-” buttons. The SCSI ID default is 6.

1

Figure 2-6. External AutoLoader SCSI and options switches

2.Set the configuration switches located on the bottom 1 of the AutoLoader, if required. See the previous section, “Switch Settings,” for switch descriptions and settings.

3.Connect the SCSI signal cable from the computer to one of the two SCSI connectors at the rear of the tabletop DAT AutoLoader.

4.Connect the external terminator (provided with the tabletop DAT AutoLoader kit) to the unused SCSI connector.