Bush Hog 2165 manual Important Safety Precautions, Tractor, Backhoe

Page 7

IMPORTANT SAFETY PRECAUTIONS

This symbol is used to call attention to safe- ty precautions that should be followed by the operator to avoid accidents. When you see this symbol, carefully read the message that follows and heed its advice. Failure to comply with safety precautions could result in serious bodily injury.

In addition to the design and configuration of equipment, hazard control and accident prevention are dependent upon the awareness, concern, prudence and proper training of personnel in the operation, transport, maintenance and storage of equipment. Lack of attention to safety can result in accident, personal injury, reduction of efficiency and worst of all—loss of life. Watch for safety hazards and correct deficiencies promptly. Use the following safety precautions as a general guide to safe operations when using this machine. Additional safety precautions are used throughout this manual for specific operating and maintenance procedures. Read this manual and review the safety precautions often until you know the limitations.

THE TRACTOR

1.Read the tractor operator’s manual to learn how to operate your tractor safely. Failure to do so could result in seri- ous injury or death and equipment damage.

2.It is recommended that tractor be equipped with Rollover Protective System (ROPS) and a seat belt be used for all loader operations.

3.Add wheel ballast or front weight for stability.

4.Move wheels to the tractor manufacturer’s widest recommended settings to increase stability.

5.For better stability, use tractor with wide front axle rather than tricycle front wheels.

6.Move and turn the tractor at low speeds.

7.Stop tractor engine, place transmission in park (or neutral), engage parking brake, lower loader arms to ground, cycle all hydraulic controls to relieve pressure, allow machine moving parts to stop, remove ignition key to prevent unauthorized person from starting engine before dismounting tractor or servicing, repairing, or making adjustments to the equipment.

8.Wear personal protective equipment (PPE) such as, but not limited to, protection for eyes, ears, lungs, head, hands and feet when operating, servicing, or repairing equipment. Avoid wearing loose clothing or jewelry that may catch and entangle on equipment moving parts.

THE BACKHOE

1.DO NOT operate the backhoe unless it is rigidly attached to the tractor or skid steer loader.

2.KNOW your controls. Read this operator’s manual and the manual provided with your tractor. Learn how to stop the tractor, the engine and the backhoe quickly in an emergency.

3.PROVIDE adequate front end weight to counter-balance the backhoe at all times. 20% of the total tractor, loader and backhoe weight must be on the tractor front axle. If unsure of weight distribution, determine at a weight scale. Total vehicle weight , including backhoe and counter weights, must not exceed the ROPS certificate for gross vehicle weight.

4.BE SURE the area is clear of overhead or underground utilities or other hazards.

5.POSITION a barricade around the work area.

6.KEEP all bystanders a safe distance away.

7.DO NOT attempt to enter operator’s platform of backhoe by using the stabilizers as a step.

8.OPERATE from the backhoe operator’s seat only.

9.ALLOW only one person to operate the backhoe at any time.

10.DISENGAGE safety locks as shown in Figures 1 & 3 before attempting to operate the backhoe.

11.NEVER dig with the backhoe unless the stabilizers are properly set.

5

Image 7
Contents Backhoes Congratulations Backhoes Table of ContentsDisclaimer of Implied Warranties & Consequential Damages This Limited Warranty Shall not Apply2165, 2175, 2185 and 2195 Backhoes Dealer Preparation Check ListYour Safety is Involved Safety Alert SymbolTractor Important Safety PrecautionsBackhoe Transportation Adjustments and InspectionAvoid HIGH-PRESSURE Fluids Osha Regulations EMPLOYERS, Employees and OperationsEmployee Tractor Operating Instructions This Act SeeksEngine Speed Keep bystanders a safe distance awayControls Operating the Backhoe Lock Pins Storage Tubes50102295 Transporting the BackhoePlacing the Stabilizers When TransportingDumping the Bucket Filling the BucketBackfilling Side Slope Excavating or TrenchingMiscellaneous Finishing Straight WallsHydraulic System Hoses ServiceBeginning of Season Bleeding Backhoe Hydraulic SystemOn Models 2165, 2175, 2185 and 2195 the follow Tooth ReplacementLubrication Tightening Nuts and BoltsRemoval from Tractor Storage Install the swing safety lock pin as shown in Figures 1Stabilizer Pads Troubleshooting ProceduresTroubleshooting Troubleshooting Load drops or settles Troubleshooting Troubleshooting Replace Center Section Assemblies Valve RepairReplacing Spool Seals General AssemblyMounting Backhoe to Tractor or Skid Steer loaders General DescriptionPoint Hitch Linkage 2165 Ag Tractor using 3-point hitchAssembly Refer to Figures 14 Point Hitch Linkage 2185/2195Assembly PTO Pump Kits Optional AssemblyDo not Remove Tractor PTO Guard Hydraulic HOOK-UP to TractorPage Closed Center System Backhoe Operation Hook-Up DiagramHydraulic Hook-Up 2175, 2185 Hook-Up RequirementsFor Tractors with OPEN-CENTER Hydraulic Systems Power Beyond KitsTractor Preparation Great Bend Backhoe & Great Bend Loader Valve Assembly Second ProcedureTractors with an auxiliary hydraulic flow of 15 gpm or less Flow Divider KIT OptionalGeneral Description Flow Divider Valve to Backhoe MountingFor Tractor Hydraulic Flow Greater than 15 GPM Testing Backhoe Hydraulic Hook-UpFlow Divider Valve to Skid Steer Adapter Mounting For Skid Steer Hydraulic For Skid Steer H Ydraulic Flow of 15 GPM or LessSeries Page Safety Decals Recommended Torque in Foot Pounds Newton Meters Torque SpecificationsBox 1039 Selma, AL 334

2165 specifications

The Bush Hog 2165 is a versatile and robust rotary cutter designed for heavy-duty lawn care and land management applications. This model is a part of the renowned Bush Hog lineup, known for its durability, efficiency, and ease of use. The 2165 strikes an excellent balance between performance and functionality, making it an ideal choice for homeowners, landscapers, and farmers alike.

One of the standout features of the Bush Hog 2165 is its impressive cutting width of 65 inches, which allows it to cover large areas quickly and effectively. This makes it particularly suitable for tackling overgrown fields, pastures, and roadside maintenance tasks. The cutter is equipped with a powerful, heavy-duty gearbox that ensures reliable performance under various conditions, providing users with the confidence to handle even the most challenging cutting jobs.

The design of the Bush Hog 2165 emphasizes user safety and comfort. The model comes with a sturdy safety shield that protects operators from flying debris during operation. Additionally, the cutter features a tough, welded frame construction, which enhances its durability and ensures that it can withstand the rigors of repeated use.

Another notable technology incorporated into the Bush Hog 2165 is its adjustable cutting height feature. This allows users to set the desired grass height easily, ranging from 1 to 4 inches. This flexibility is crucial for achieving the perfect lawn look and accommodating different mowing requirements throughout the seasons.

The 2165 also includes high-capacity cutting blades designed to provide a clean and consistent cut. The blades can be replaced or sharpened easily, further enhancing the cutter's practicality and extending its lifespan. Furthermore, the model is compatible with a variety of tractors, making it a versatile attachment that fits seamlessly into many existing agricultural setups.

Overall, the Bush Hog 2165 rotary cutter is engineered for reliability and performance. Its blend of advanced technologies, safety features, and user-friendly design make it an excellent choice for anyone in need of a dependable mowing solution. Whether for personal gardening projects or professional landscape management, the Bush Hog 2165 excels in meeting the demands of diverse applications, ensuring users achieve their landscaping goals efficiently and effectively.