Billy Goat BC2403 Series owner manual Operation

Page 10

BC2403 Series Brush Cutter Owner’s Manual

OPERATION

DO NOT run engine in an enclosed area. Exhaust gases contain carbon monoxide, an odorless and possibly fatal poison.

DO NOT start or operate engine if strong odor of gasoline is present.

DO NOT start or operate engine if gasoline is spilled. Move equipment away from spill until gasoline has completely evaporated.

DO NOT operate engine without a muffler. Inspect muffler periodically and replace if necessary. If equipped with muffler deflector, inspect deflector periodically and replace if necessary.

DO NOT operate engine with grass, leaves or other combustible material near the muffler.

DO NOT touch muffler, cylinder or cooling fins while engine is running. Contact with hot surfaces may cause severe burns.

DO NOT operate equipment with bystanders in or near the work area.

DO NOT operate equipment with guards removed.

DO NOT operate equipment in areas containing rock, glass, string-like material, wire, rags, cans, metal or other non-organic material.

DO NOT operate equipment on slopes greater than specified in Specifications section of this manual.

DO NOT operate equipment near hot or burning debris or any toxic or explosive materials.

DO NOT allow children to operate this equipment.

ALWAYS keep hands and feet away from moving or rotating parts.

ALWAYS check before use, transportation, or storage to make sure the battery is secured and straps holding battery are in good condition. If the strap breaks it will allow the battery to shift and could cause a short damaging the equipment. (Electric start)

ALWAYS connect battery terminals to proper connection cables. (Electric Start)

EAR PROTECTION is recommended when operating this equipment.

EYE PROTECTION is recommended when operating this equipment.

Part No 500360

10

F050208A

Image 10
Contents Billy Goat BC2403 Series Brush Cutter Contents About this ManualCommon Replacement Parts BC 2403 Series SpecificationsSerial Plate Data General Safety Instructions and Symbols F050208A Vibration Data Sound DataIntended USE Engine Labels Instruction LabelsBriggs and Stratton Brush Cutter Assembly Drawing Assembly Instructions Disconnect spark plug wire before assembling unitOperation Operator Controls StartingF050208A Cutting Shut Down Clearing a Clogged Cutting DeckHandling and Transporting StoragePeriodic Maintenance MaintenanceCleaning Blade Removal and Sharpening Blade Drive Belt Tension Adjustment Blade Clutch Adjustment Blade Drive Belt Removal and Replacement Front Transaxle Drive Clutch Adjustment Transaxle Cable Adjustment Reconnect spark plug wireTransaxle Drive Belt Removal and Replacement Starter Switch Wiring Wiring DiagramsStarter Circuit Schematic Diagram Troubleshooting Problem Possible Cause Corrective ActionEngine Maintenance and Repair Warranty Claim ProcedureMaintenance Record Illustrated Parts List Engine and Engine Base AssemblyDescription BC2403HEB Handlebar Assembly Description QTY Transaxle and Blade Deck Assembly F032608A Blade Drive Spindle Assembly Detail Drawing Description BC2403HEB F050208A