Billy Goat Official Brush Cutter Manual for Equipment

Page 4

BC2403 Series Brush Cutter Owner’s Manual

GENERAL SAFETY INSTRUCTIONS and SYMBOLS

The safety symbols shown below are used throughout this manual. You should be thoroughly familiar with them before assembling, operating or servicing this equipment.

This symbol indicates important information that will prevent injury to yourself or others.

This symbol indicates ear protection is recommended when operating this equipment.

This symbol indicates eye protection is recommended when operating this equipment.

This symbol indicates gloves should be worn when servicing this equipment.

This symbol indicates that this manual and the engine manufacturer’s manual should be read carefully before assembling, operation or servicing this equipment.

This symbol indicates important information that will prevent damage to your BILLY GOAT ® Brush Cutter.

This symbol indicates the engine oil level should be checked before operating this equipment.

Read and make sure you thoroughly understand the following safety precautions before assembling, operating or servicing this equipment:

READ this manual and the engine manufacturer’s manual carefully before assembling, operating or servicing this equipment.

EAR PROTECTION is recommended when operating this equipment.

EYE PROTECTION is recommended when operating this equipment.

EXHAUST from this product contains chemicals known to the State of California to cause cancer, birth defects or other reproductive harm.

DO NOT operate this equipment on any unimproved forested, brushy, or grass covered land unless a spark arrester is installed on the muffler as required by Section 4442 of the California Public Resources Code. The arrester must be maintained in good working order. Other states may have similar laws. Federal laws apply on federal lands.

DO NOT run engine in an enclosed area. Exhaust gases contain carbon monoxide, an odorless and possibly fatal poison.

Part No 500360

4

F050208A

Image 4
Contents Billy Goat BC2403 Series Brush Cutter Contents About this ManualCommon Replacement Parts BC 2403 Series SpecificationsSerial Plate Data General Safety Instructions and Symbols F050208A Vibration Data Sound DataIntended USE Engine Labels Instruction LabelsBriggs and Stratton Brush Cutter Assembly Drawing Assembly Instructions Disconnect spark plug wire before assembling unitOperation Operator Controls StartingF050208A Cutting Shut Down Clearing a Clogged Cutting DeckHandling and Transporting StoragePeriodic Maintenance MaintenanceCleaning Blade Removal and Sharpening Blade Drive Belt Tension Adjustment Blade Clutch Adjustment Blade Drive Belt Removal and Replacement Front Transaxle Drive Clutch Adjustment Transaxle Cable Adjustment Reconnect spark plug wireTransaxle Drive Belt Removal and Replacement Starter Switch Wiring Wiring DiagramsStarter Circuit Schematic Diagram Troubleshooting Problem Possible Cause Corrective ActionEngine Maintenance and Repair Warranty Claim ProcedureMaintenance Record Illustrated Parts List Engine and Engine Base AssemblyDescription BC2403HEB Handlebar Assembly Description QTY Transaxle and Blade Deck Assembly F032608A Blade Drive Spindle Assembly Detail Drawing Description BC2403HEB F050208A