Billy Goat BC2403 Series owner manual Operator Controls, Starting

Page 11

BC2403 Series Brush Cutter Owner’s Manual

OPERATOR CONTROLS

The operator’s station is at the rear of the machine between the handlebars. The operator should STAND in a position to allow both handlebars to be grasped firmly and which allows sufficient leverage to steer the machine. Operator’s controls are shown below.

1

2

3

	Operator Control Locations
1	Blade Clutch Lever 5		ON/OFF Switch
2	Gear Shift Lever	6	Drive Clutch Lever
3	Choke	7	Pull Starter
4	Throttle

STARTING

CHECK engine oil level before operating machine.

4

5

6

7

1.Place equipment on a level, firm surface that is free of rocks or other debris.

2.Place throttle in START position.

Throttle

Part No 500360

11

F050208A

Image 11

Contents Billy Goat BC2403 Series Brush Cutter About this Manual ContentsSerial Plate Data BC 2403 Series SpecificationsCommon Replacement Parts General Safety Instructions and Symbols F050208A Intended USE Sound DataVibration Data Briggs and Stratton Instruction LabelsEngine Labels Brush Cutter Assembly Drawing Disconnect spark plug wire before assembling unit Assembly InstructionsOperation Starting Operator ControlsF050208A Cutting Clearing a Clogged Cutting Deck Shut DownStorage Handling and TransportingCleaning MaintenancePeriodic Maintenance Blade Removal and Sharpening Blade Drive Belt Tension Adjustment Blade Clutch Adjustment Blade Drive Belt Removal and Replacement Front Transaxle Cable Adjustment Reconnect spark plug wire Transaxle Drive Clutch AdjustmentTransaxle Drive Belt Removal and Replacement Starter Circuit Schematic Diagram Wiring DiagramsStarter Switch Wiring Problem Possible Cause Corrective Action TroubleshootingWarranty Claim Procedure Engine Maintenance and RepairMaintenance Record Engine and Engine Base Assembly Illustrated Parts ListDescription BC2403HEB Handlebar Assembly Description QTY Transaxle and Blade Deck Assembly F032608A Blade Drive Spindle Assembly Detail Drawing Description BC2403HEB F050208A