Billy Goat BC2403 Series owner manual Periodic Maintenance, Cleaning

BC2403 Series Brush Cutter Owner’s Manual

MAINTENANCE

PERIODIC MAINTENANCE

Periodic maintenance should be performed at the following intervals:

Maintenance Operation	Every Use	Daily or Every 5	Every 25 Hours	Every 50	Every 100-150
		Hours		Hours	Hours
Inspect for worn or damaged parts.	z
Check for excessive vibration		z
Inspect for loose parts.		z
Sharpen blade.			z
Inspect belts for wear.			z
Lubricate throttle control cable and linkage.			z
Check blade clutch cable tension.				z
Inspect battery for corrosion, damage or leaks				z
(electric start units only).
Apply anti-seize compound to rear axles.				z
Check battery strap for excessive wear or rips	z
Replace blade drive and transaxle drive belts.					z

CLEANING

Your BILLY GOAT ® Brush Cutter should be cleaned periodically to ensure optimum performance and service life. Clogs and debris should be removed from the blade area and debris should be removed from the engine cooling fins. A garden hose or pressure washer may be used for cleaning.

DO NOT SPRAY WATER DIRECTLY ON THE BLADE CLUTCH WHEN USING A POWER WASHER. SEE FIGURE BELOW.

Part No 500360 16 F050208A