Billy Goat BC2403 Series Assembly Instructions, Disconnect spark plug wire before assembling unit

BC2403 Series Brush Cutter Owner’s Manual

ASSEMBLY INSTRUCTIONS

Your BILLY GOAT ® BC Self-Propelled Brush Cutter was shipped in one carton, completely assembled except for the upper handle assembly and the front guard bar. Mounting hardware for the handle and guard bar is temporarily installed on the lower handle and the front of the deck assembly.

READ all safety instructions before assembling unit.

Electric start units are shipped without a battery. A CB18, C50, SC50 or MCB50 series dry or wet battery with a 17.2 Ah rating is required.

Numbers in parenthesis ( ) refer to item numbers on Figure 1 on the facing page.

1.Remove unit from carton. Make sure the following items that have been packed with unit:

†Upper Handle Assembly, P/N 500256

†Guard Bar, P/N 500356

†Bar Skids, P/N 500355

†Owner’s Manual, P/N 500264

†Honda or Briggs and Stratton Engine Manual

†Warranty Card, P/N 400972

†Ty-Wraps (4 ea)

DISCONNECT spark plug wire before assembling unit.

2.Remove mounting hardware (144, 143, 115, 117, 141) from lower handles (51 and 52).

3.Loosen (but do not remove) four screws (115) securing the lower handles (51 and 52).

4.Attach upper handle (40) to lower handles (51 and 52) with hardware removed in step 2. Tighten finger tight only.

5.Make sure engine pull starter is properly installed in guide (145) and then tighten upper handle fasteners (Honda engine only).

6.Tighten mounting hardware on handle braces (5 and 6).

7.Remove mounting hardware (33, 117, 119, and 141) from bar brace (31) and skids (155).

8.Place a wood block under the deck and attach the skids using hardware removed from them. Use the bottom two holes on the longer end to attach to the front of the deck.

Warning: When attaching the Skids be careful of the blade. Wear thick gloves and check the position of the blade before putting your hands into the deck to install the bolts though the Skids.

9.Attach guard bar (31) to Skid bar by installing the side bolts into the top two holes on the skids.

10.For electric start models secure the battery (not included) in the battery plate (164), hook one side of the strap into the hole then stretch the strap across the top of the battery and hook the opposite side into the opposing hole on the plate. Make sure the battery will not move then connect terminals.

Items 117, 119 and 141 secure both front skid attachment and sides of front guard bar. Make sure both are securely attached.

11.Reconnect spark plug wire.

Part No 500360 9 F050208A