Exmark 4500-872 manual Safety

Page 10

Safety

WARNING

Hydraulic fluid escaping under pressure can penetrate skin and cause injury. Fluid accidentally injected into the skin must be surgically removed within a few hours by a doctor familiar with this form of injury or gangrene may result.

If equipped, make sure all hydraulic fluid hoses and lines are in good condition and all hydraulic connections and fittings are tight before applying pressure to hydraulic system.

Keep body and hands away from pinhole leaks or nozzles that eject high pressure hydraulic fluid.

Use cardboard or paper, not your hands, to find hydraulic leaks.

Safely relieve all pressure in the hydraulic system by placing the motion control levers in neutral and shutting off the engine before performing any work on the hydraulic system.

10

Image 10
Contents Lazer Z E-SERIES California Introduction Contents Safe Operating Practices SafetySafety Alert Symbol TrainingSafety Operation Slope OperationUsing the Rollover Protection System Rops Maintenance and StorageSafety Safety Safety and Instructional Decals 109-7232 109-8483 116-2927 Model Numbers SpecificationsSystems Tires & Wheels SeatHydrostatic Ground Drive System Cutting DeckDimensions Accessory Weight Table Worksheet Torque RequirementsControls Product OverviewOperation Motion Control LeversThrottle Control Ignition SwitchChoke Control Brake LeverFuel Gauge Fuel Shut-Off ValveDrive Wheel Release Valves Pre-Start Operating InstructionsStarting the Engine Open the Fuel Shut-Off ValveEngaging the PTO Stopping the Engine Disengaging the PTODriving the Machine Adjusting the Cutting Height Driving ForwardAdjusting the Deck Lift Foot Pedal 48 & 52 inch Decks Only Adjusting the Anti-Scalp RollersTransporting Transporting a UnitLoading a Unit Maintenance Recommended Maintenance SchedulesCheck Battery Charge Check Engine Oil LevelRecommended Jump Starting Procedure Service Interval As requiredCheck Safety Interlock System Check Mower BladesCheck Seat Belt Service Air CleanerCheck Rollover Protections Systems Roll Bar Knobs Check for Loose HardwareCheck Tire Pressures Check Hydraulic Oil LevelCheck Condition Of Belts Lubricate Grease Fittings Lubricate Caster Wheel HubsCheck Spark Plugs Lubricate Brake Handle PivotLubricate Deck Lift Pivot Change Fuel FilterCopper-Based Anti-seize Wheel Hub Slotted Nut Torque SpecificationThread Locking Adhesives Check Spark Arrester if equippedAdjustments Deck LevelingPump Drive Belt Tension Adjusting the Parking BrakeDeck Belt Tension Left Hand Brake Shown Electric Clutch Adjustment Start the mower while in the operator positionMotion Control Linkage Adjustment Motion Control Damper Adjustment RH Motion Control ShownMotion Control Neutral Lock Pivot Adjustment Motion Control Handle AdjustmentRemove Engine Shrouds and Clean Cooling Fins Caster Pivot Bearings Pre-Load AdjustmentClean Engine and Exhaust System Area Clean Hydro Cooling FinsBattery Disposal Clean Debris From MachineClean Grass Build-Up Under Deck Waste DisposalTroubleshooting Problem Possible Cause Corrective ActionSee Drive Wheel Release Valves section Troubleshooting Schematics Electrical DiagramSchematic ElectricalHydraulic Diagram Lazer Z E-Series Turf Equipment Page This page may be copied for personal use See EXMARK’S Complete Line of Accessories and Options