Maintenance
Figure 16
Right-Hand Side of Unit Shown
1. | 3. Remove |
holes to reduce spring | washer. |
tension. |
|
2.Weight transfer spring.
7.Re-install the left fender
8.For additional weight transfer adjustment, repeat steps 4 through 7 on the right side of the unit.
Caster Pivot Bearings Pre-Load Adjustment
Remove dust cap from caster and tighten nyloc nut until washers are flat and back off 1/4 of a turn to properly set the
Figure 17
1.Spring disc washers
Cleaning
Clean Engine Cooling System
Service Interval: Before each use or daily (May be required more often in dry or dirty conditions.)
CAUTION
Excessive debris around the engine cooling air intake and inside of the pump drive belt compartment and damaged or missing rubber baffles can cause the engine and hydraulic system to overheat which can create a fire hazard.
Clean all debris from inside of pump drive belt compartment daily.
1.Stop engine, wait for all moving parts to stop, and remove key. Engage parking brake.
2.Clean all debris from rotating engine air intake screen and from around engine shrouding.
3.Clean all debris from around the engine and drive belts.
Remove Accumulated Debris from Engine (Briggs & Stratton Units Only)
Service Interval: Before each use or daily
Engine parts should be kept clean to reduce the risk of overheating and ignition of accumulated debris.
1.Stop engine, wait for all moving parts to stop, and remove key. Engage parking brake.
2.Remove front panel from engine and clean around the intake manifold, fuel pump, and carburetor.
3.Reinstall the front panel.
Important: Do Not use water to clean engine. Use low pressure compressed air. See Engine Owner’s Manual.
34