Exmark Metro manual This Clearance should be Equal Shifter Lever To Transmission

Page 18

FIG. 8

THIS CLEARANCE SHOULD BE EQUAL

FIG. 7

SHIFTER LEVER

TO TRANSMISSION

FIG. 9

THIS CLEARANCE SHOULD BE EQUAL

3.8.5Install and adjust wheel drive linkages.

a)Screw threaded end of drive linkages into swivels in wheel drive idler arms.

b)Insert clevis pin from bolt bag through drive linkage, lever and slot in the neutral lock/park brake latches (See Figure 10). Make proper adjustments before adding hairpins.

Neutral Lock/Park Brake

Clevis Pin

Drive Linkage

Drive Lever

FIG. 10

LEVER AND ROD

ADJUSTMENT

c)Adjust drive linkage length by threading into or out of the swivel until there is a 3/16" to 1/4" clearance between the linkage assembly and the bottom of the slot in the neutral lock/park brake latch (See Figure 11).

- 13 -

Image 18

Contents Page Potential Hazard Exmark Parts PLUS Program Operators Manual Table of Contents Safety Alert Symbol SafetyYour Safety is Involved TrainingPotential Hazard Operation Maintenance and Storage Safety Signs Riding AttachmentsPage Specifications Dimensions Wheel Drive SystemTires Assembly Instructions Torque RequirementsUpper Handle Height Adjustment Kohler Speed Control Throttle Cable HOOK-UPHP Kawasaki Speed Control Throttle Cable HOOK-UP 15 & 17 HP Kawasaki Speed Control Throttle Cable HOOK-UPFor 12.5 HP Kawasaki, 10.5 HP B&S and Kohler engines For 15 & 17 HP Kawasaki enginesLever and ROD Adjustment This Clearance should be Equal Shifter Lever To TransmissionNeutral Lock Lever Clearance Drive Lever Hardware LocationOperation Instructions ControlsDrive LEVER, Neutral LOCK/PARK Brake Latch Operation PRE-START Be sure ignition switch is in the OFF position Operating Instructions Rotating blades under the mower deck are dangerous Maintenance and Adjustments Periodic MaintenanceTransporting Service Interval Daily Blade Bolt Installation Service Interval 40 hrs Service Interval 160 hrsLubrication Chart Service Interval Refer to ChartSpray Lubricant Chart Service IntervalPivot Points Adjustments Caster Height Adjustment Axle NO. of Spacers Number of 1/4 Blade Spacers PositionCutter Deck Belt Adjustment Blade Brake Adjustment 32 & 36 Belt Guide LocationDrive Belt Tension Adjustment Positions Mower Pulling Left or Right Trouble ShootingBlades do not Stop When Disengaged Mower Cuts UnevenlyMower Deck Belt Routing Engine TroubleshootingEngine Troubleshooting Table 36 Mower DeckWiring Diagrams Warranty Page Service Record Date Description of Work DoneFold Along Appropriate Line Exmark MFG. CO. INC Industrial Park BOXBEATRICE, NE ALL Rights Reserved