Exmark Metro manual Service Interval Daily

Page 27

WARNING

POTENTIAL HAZARD

The engine can become very hot.

WHAT CAN HAPPEN

Touching a hot engine can cause severe burns.

HOW TO AVOID THE HAZARD

Allow the engine to cool completely before service or making repairs around the engine area.

5.1.1Check engine oil level.

Service Interval: See Engine Owner's Manual

a)Make sure engine is stopped and on a level surface.

b)Check with engine cold.

c)Clean area around dipstick. Remove dip stick and wipe off oil. Reinsert the dipstick and:

Screw dipstick into place for the B&S engines.

Do not screw into place for Kawasaki or Kohler engines. Remove dipstick and check oil level.

d)If the oil level is low, add oil as specified in the engine owners manual to bring the oil level up to the "F" mark on the dipstick. DO NOT OVERFILL.

IMPORTANT: Do Not operate the engine with oil level below the "L" mark on the dipstick or over the "F" mark.

5.1.2Clean engine air cooling system.

Service Interval: See Engine Owner's Manual

a)Stop engine and remove spark plug wire(s).

b)Clean all debris from engine air intake screen and from around engine shrouding.

5.1.3Clean grass build-up under deck and check mower blades.

Service Interval: Daily

CAUTION

POTENTIAL HAZARD

Raising the mower deck for service or maintenance relying solely on mechanical or hydraulic jacks could be dangerous.

WHAT CAN HAPPEN

The mechanical or hydraulic jacks may not be enough support or may misfunction allowing the unit to fall, which could cause injury.

HOW TO AVOID THE HAZARD

DO NOT rely solely on mechanical or hydraulic jacks for support. Use adequate jack stands or equivalent support.

- 22 -

Image 27
Contents Page Potential Hazard Exmark Parts PLUS Program Operators Manual Table of Contents Training SafetyYour Safety is Involved Safety Alert SymbolPotential Hazard Operation Maintenance and Storage Riding Attachments Safety SignsPage Specifications Dimensions Wheel Drive SystemTires Torque Requirements Assembly InstructionsKohler Speed Control Throttle Cable HOOK-UP Upper Handle Height Adjustment15 & 17 HP Kawasaki Speed Control Throttle Cable HOOK-UP HP Kawasaki Speed Control Throttle Cable HOOK-UPFor 15 & 17 HP Kawasaki engines For 12.5 HP Kawasaki, 10.5 HP B&S and Kohler enginesThis Clearance should be Equal Shifter Lever To Transmission Lever and ROD AdjustmentDrive Lever Hardware Location Neutral Lock Lever ClearanceControls Operation InstructionsDrive LEVER, Neutral LOCK/PARK Brake Latch Operation PRE-START Be sure ignition switch is in the OFF position Operating Instructions Rotating blades under the mower deck are dangerous Maintenance and Adjustments Periodic MaintenanceTransporting Service Interval Daily Blade Bolt Installation Service Interval 160 hrs Service Interval 40 hrsService Interval Refer to Chart Lubrication ChartSpray Lubricant Chart Service IntervalPivot Points Adjustments Axle NO. of Spacers Number of 1/4 Blade Spacers Position Caster Height AdjustmentCutter Deck Belt Adjustment 32 & 36 Belt Guide Location Blade Brake AdjustmentDrive Belt Tension Adjustment Positions Mower Cuts Unevenly Trouble ShootingBlades do not Stop When Disengaged Mower Pulling Left or Right36 Mower Deck Engine TroubleshootingEngine Troubleshooting Table Mower Deck Belt RoutingWiring Diagrams Warranty Page Date Description of Work Done Service RecordFold Along Appropriate Line Exmark MFG. CO. INC Industrial Park BOXBEATRICE, NE ALL Rights Reserved