Exmark Metro manual Operating Instructions

Page 24

4.3OPERATING INSTRUCTIONS

4.3.1Read the Engine Owner's Manual carefully for detailed operating instructions and maintenance regarding the engine.

Before attempting to operate the unit, refer to Section 1 (Safety) and follow all safety, operating, and preparation guidelines as stated in that section.

4.3.2Starting Engine

Position mower on a level surface. Disengage blade drive and place transmission in neutral.

Open fuel shut-off valve.

NOTE: Always engage the left and right neutral lock/park brake latches in the “park brake” position when starting the engine (See Section 4.1.3).

WARNING

POTENTIAL HAZARD

Engine exhaust contains carbon monoxide, which is an odorless deadly poison.

WHAT CAN HAPPEN

Carbon monoxide can kill you and is also known to the State of California to cause birth defects.

HOW TO AVOID THE HAZARD

Do not run engine indoors or in a small confined area where dangerous carbon monoxide fumes can collect.

With a cold engine place the throttle in the full "choke" position. For 15 & 17 HP Kawasaki units turn the key switch to the “Run” position. With a warm engine, place the throttle midway between the "slow" and "fast" position.

NOTE: Kawasaki engines generally need to be "choked" even when warm.

Pull recoil rope to start engine. After engine starts, move throttle control out of the choke position.

4.3.3Stopping Engine:

Disengage blade drive, shift transmission to neutral and lock the drive levers in “park brake” position. Move throttle to "slow" position.

Allow engine to idle for 30 seconds to allow cool down then:

For 12.5 HP Kawasaki, Kohler, and 10.5 HP B&S engines: Move throttle to full rear position to stop the engine.

For 15 & 17 HP Kawasaki engines: Turn the key to the “Off” position

Close fuel shut-off valve if machine will not be used for a few days; when parking inside a building; or when transporting the unit.

- 19 -

Image 24
Contents Page Potential Hazard Exmark Parts PLUS Program Operators Manual Table of Contents Safety Your Safety is InvolvedSafety Alert Symbol TrainingPotential Hazard Operation Maintenance and Storage Safety Signs Riding AttachmentsPage Specifications Dimensions Wheel Drive SystemTires Assembly Instructions Torque RequirementsUpper Handle Height Adjustment Kohler Speed Control Throttle Cable HOOK-UPHP Kawasaki Speed Control Throttle Cable HOOK-UP 15 & 17 HP Kawasaki Speed Control Throttle Cable HOOK-UPFor 12.5 HP Kawasaki, 10.5 HP B&S and Kohler engines For 15 & 17 HP Kawasaki enginesLever and ROD Adjustment This Clearance should be Equal Shifter Lever To TransmissionNeutral Lock Lever Clearance Drive Lever Hardware LocationOperation Instructions ControlsDrive LEVER, Neutral LOCK/PARK Brake Latch Operation PRE-START Be sure ignition switch is in the OFF position Operating Instructions Rotating blades under the mower deck are dangerous Maintenance and Adjustments Periodic MaintenanceTransporting Service Interval Daily Blade Bolt Installation Service Interval 40 hrs Service Interval 160 hrsLubrication Chart Service Interval Refer to ChartSpray Lubricant Chart Service IntervalPivot Points Adjustments Caster Height Adjustment Axle NO. of Spacers Number of 1/4 Blade Spacers PositionCutter Deck Belt Adjustment Blade Brake Adjustment 32 & 36 Belt Guide LocationDrive Belt Tension Adjustment Positions Trouble Shooting Blades do not Stop When DisengagedMower Pulling Left or Right Mower Cuts UnevenlyEngine Troubleshooting Engine Troubleshooting TableMower Deck Belt Routing 36 Mower DeckWiring Diagrams Warranty Page Service Record Date Description of Work DoneFold Along Appropriate Line Exmark MFG. CO. INC Industrial Park BOXBEATRICE, NE ALL Rights Reserved